Abstract:As the development of metamaterials, the acoustic cloaking has attracted extensive attention due to its novel physics and potential application. In recent years, based on the phase reimbursement modulation from Generalized Snell’s law and coordinate transformation, the acoustic cloakings underwater and in the air have both received broad and in-depth researches. However, there is still an urgent need to design acoustic cloaks that are thinner and less affected by the incident angle of acoustic waves. Further, the designed cloaks should have a relative wider operating band and be more suitable for irregular objects. In this paper, an ultrathin curved acoustic metasurface carpet cloaking is studied by using of phase reimbursement modulation. The phase modulation is based on Helmholtz resonances (HR). The metasurface carpet is immersed in air, since the vibration mode of acoustic waves in the air is relatively single, thus the physical essence can be elucidated more clearly. The carpet cloak is constructed by 52 Helmholtz resonant units, and the size of resonant unit is less than 0.2 of working wavelength. The phase change of HR unit is solved analytically by using of the Generalized Snell’s law, and confirmed by the Multiphysics COMSOL software. The parameter effects of HR unit on the phase change is studied. It demonstrates that, the phase change of HR unit is sensitive for the change of height and radii of HR unit, while the change of width of HR cavity neck can make the phase of HR unit smoothly change. Therefore, the width of HR cavity neck is designed in constructing the 52 HR units, and the height and radii of HR unit stay fixed. The simulating results demonstrate that the designed cloak works well in the frequency ranging from 5850Hz to 7550Hz. Also, we study the cloaking effect for oblique incidence, showing that the carpet cloak works well for incident angle is less than 30°. To quantitative analysis of the bandwidth of the cloaking, we calculate the Cosine Similarity (CSI) value. It elucidates that, the value of the cloak is great close to that of the flat ground in the corresponding working frequency range. The cloak designed in this paper are made up by the ultrathin Helmholtz Resonant structures, which is simple and easy to realize and is useful for potential applications.

An Ultrathin Directional Carpet Cloak Based on Generalized Snell'S Law

Carpet cloak for water waves.

Far Field Free-Space Measurement of Three Dimensional Hole -in -Teflon Invisibility Cloak.

Homogeneous Anisotropic Dielectric Invisibility Carpet Cloak Made of Al2o3 Plates

Experimentally Demonstrated A Unidirectional Electromagnetic Cloak Designed by Topology Optimization

A 3D Carpet Cloak with Non‐Euclidean Metasurfaces

A Unidirectional TM-Wave Cloak with Full Parameters

Ultrathin Conformal Magnetic Invisible Cloak for Irregular Objects.

An Ultra-Thin Skin Cloak for Electromagnetic, Acoustic and Water Wave

Broad Band Invisibility Cloak Made of Normal Dielectric Multilayer

Fourier Metasurface Cloaking: Unidirectional Cloaking of Electrically Large Cylinder under Oblique Incidence.

Ultrathin acoustic metasurface carpet cloaking based on Helmholtz resonances

Carpet Cloak with Photonic Crystal Shield That Permits Information Exchange

Extremely Thin Dielectric Metasurface for Carpet Cloaking

Carpet cloaking on a dielectric half-space

Dielectric Carpet Cloaking Device Based on Feflection Phase Metasurface

Te-polarized Microwave Broadband Carpet Cloak

Low Scattering Broadband Cylindrical Invisibility Cloak in Free-Space

Phase‐preserved Macroscopic Visible‐light Carpet Cloaking Beyond Two Dimensions

Infrared Carpet Cloak Designed With Uniform Silicon Grating Structure

Three dimensional acoustic carpet cloak based on an ultrathin metasurface