Abstract:It has recently been shown that solid-state nanometer-scale pores ('nanopores') can be used as highly sensitive single-molecule sensors. For example, electrophoretic translocation of DNA, RNA and proteins through such nanopores has enabled both detection and structural analysis of these complex biomolecules. Control over the nanopore size is critical as the pore must be comparable in size to the analyte molecule in question. The most widely used fabrication methods are based on focused electron or ion beams and thus require (scanning) transmission electron microscopy and focused ion beam (FIB) instrumentation. Even though very small pores have been made using these approaches, several issues remain. These include the requirement of being restricted to rather thin, mechanically less stable membranes, particularly for pore diameters in the single-digit nanometer range, lack of control of the surface properties at and inside the nanopore, and finally, the fabrication cost. In the proof-of-concept study, we report on a novel and simple route for fabricating metal nanopores with apparent diameters below 20 nm using electrodeposition and real-time ionic current feedback in solution. This fabrication approach inserts considerable flexibility into the kinds of platforms that can be used and the nanopore membrane material. Starting from much larger pores, which are straightforward to make using FIB or other semiconductor fabrication methods, we electrodeposit Pt at the nanopore interface while monitoring its ionic conductance at the same time in a bi-potentiostatic setup. Due to the deposition of Pt, the nanopore decreases in size, resulting in a decrease of the pore conductance. Once a desired pore conductance has been reached, the electrodeposition process is stopped by switching the potential of the membrane electrode and the fabrication process is complete. Furthermore, we demonstrate that these pores can be used for single-biomolecule analysis, such as that of λ-DNA, which we use in a proof-of-concept study. Importantly, our approach is applicable to single nanopores as well as nanopore arrays, and can easily be extended to deposits of metal other than Pt.

Trapping And Identifying Single-Nanoparticles Using A Low-Aspect-Ratio Nanopore

Electrical Trapping Mechanism of Single-Microparticles in A Pore Sensor

Etching-Engineered Low-Voltage Dielectrophoretic Nanotweezers for Trapping of Single Molecules.

Monolithic Integration of Vertical Thin-Film Transistors in Nanopores for Charge Sensing of Single Biomolecules

Single-nanoparticle Detection Using a Low-Aspect-ratio Pore.

Light-Driven Conversion of Silicon Nitride Nanopore to Nanonet for Single-Protein Trapping Analysis

Tailoring Particle Translocation Via Dielectrophoresis In Pore Channels

Field Effect Control of Translocation Dynamics in Surround-Gate Nanopores

Particle Trajectory-Dependent Ionic Current Blockade in Low-Aspect-Ratio Pores

An Integrated System for Optical and Electrical Detection of Single Molecules/particles Inside a Solid-State Nanopore

Nano-Optical Tweezing of Single Proteins in Plasmonic Nanopores

In-tube micro-pyramidal silicon nanopore for inertial-kinetic sensing of single molecules

Detection of Single Proteins with a General Nanopore Sensor

Investigation of entrance effects on particle electrophoretic behavior near a nanopore for resistive pulse sensing

Nanopore Confinement for Electrochemical Sensing at the Single-Molecule Level

Control of particle trapping in a magnetoplasmonic nanopore

Electrochemically Confined Nanopore Analysis: from Single Molecule to Single Cell

Angular‐Inertia Regulated Stable and Nanoscale Sensing of Single Molecules Using Nanopore‐In‐A‐Tube

Precise electrochemical fabrication of sub-20 nm solid-state nanopores for single-molecule biosensing

Preparation and application of nanopores for single molecule detection

Single-entity Measurement Based on Electro-optical Confinement of Nanopores