Abstract:The properties of the extracellular matrix (ECM) have profound impact upon cell behaviour. As an abundant protein in mammals, collagen is a desirable base material to engineer an ECM tissue scaffold, but its structural weakness generally requires molecular crosslinking or incorporation of additional ECM-based macromolecules such as glycosaminoglycans. We have performed microscopic indentation to test collagen films under dry and aqueous conditions prepared with different levels of physical and chemical crosslinking. Our technique isolates intrinsic properties of the poro-viscoelastic matrix in a regime minimizing the influence of drainage hydrodynamics and allows direct measurement of the effect of hydrating a specific sample. A doubling of the effective stress-strain stiffness under crosslinking could be directly correlated to structural changes in X-ray diffraction spectra, while electron microscopy revealed possible fibril bridging mechanisms explaining observed toughness. Overall, an intrinsic viscoelastic stress-strain response of collagen under various conditions of cross-linking was observed for both dry and wet conditions, with the latter most affected by indentation rate. Under creep testing, a three order of magnitude increase in dynamic compliance and factor three reduction in relaxation time was found going from the dry to hydrated state. When fitted to a simple viscoelastic model, crosslinking showed a tendency to decrease relaxation time in both states, but reduced dynamic compliance only in the hydrated case. This suggests a reduced role of virtual crosslinks under hydration. This is the first study reporting consistent mechanical testing of dry and hydrated ECM-derived biomaterials, accessing the intrinsic material mechanics under in vivo-like conditions. STATEMENT OF SIGNIFICANCE: This manuscript presents new insights into the effect of crosslinking on mechanical properties of dry and hydrated collagen intended for tissue scaffolding applications. A novel microscopic indentation technique allowed testing of the poro-viscoelastic matrix isolated in a regime minimizing the influence of drainage hydrodynamics, so direct comparison of the effect of hydration on the intrinsic material behaviour to could be made. A variety of experimental techniques including X-ray diffraction, infrared spectroscopy, and scanning electron and atomic force microscopy were used to augment the mechanical testing. The results of creep testing were numerically analysed using a four-component viscoelastic model. This is the first mechanical testing of dry and hydrated ECM-derived biomaterials, accessing the intrinsic material mechanics under in vivo-like conditions.

Frictional Properties of Native and Functionalized Type I Collagen Thin Films

A Novel Combined Polyphenol-Aldehyde Crosslinking of Collagen Film-Applications in Biomedical Materials.

Micromechanical Analysis of Native and Cross-Linked Collagen Type I Fibrils Supports the Existence of Microfibrils

A multiscale investigation into the role of collagen-hyaluronan interface shear on the mechanical behaviour of collagen fibers in annulus fibrosus - Molecular dynamics-cohesive finite element-based study

Dry vs. wet: Properties and performance of collagen films. Part II. Cyclic and time-dependent behaviours

Mechanical properties of native and cross-linked type I collagen fibrils.

Ultrastructural viscoelastic behavior of collagen identified by AFM nano-dynamic mechanical analysis

Quantitative Analyses of Dynamic Features of Fibroblasts on Different Protein-Coated Compliant Substrates.

Preparation And Properties Of Cellulose Nanocrystals Reinforced Collagen Composite Films

Polyelectrolyte multilayer nanofilms used as thin materials for cell mechano-sensitivity studies.

Nanomechanical characterization of micro/nanofiber reinforced type I collagens.

A Quantitative Study of MC3T3-E1 Cell Adhesion, Morphology and Biomechanics on Chitosan–collagen Blend Films at Single Cell Level

Strain localization and yielding dynamics in disordered collagen networks

Quantifying the interactions between biomimetic biomaterials - collagen I, collagen IV, laminin 521 and cellulose nanofibrils - by colloidal probe microscopy

Effect of cross-linking and hydration on microscale flat punch indentation contact to collagen-hyaluronic acid films in the viscoelastic limit

Insights into role of synergistic interplay among collagen type I, collagen type II, and water on the structure and nanomechanics of collagen fibrils in annulus fibrosus: a molecular dynamics study

Unraveling capillary interaction and viscoelastic response in atomic force microscopy of hydrated collagen fibrils

Collagen Films with Stabilized Liquid Crystalline Phases and Concerns on Osteoblast Behaviors

Modification of Collagen with a Natural Cross-Linker, Procyanidin

Heterogeneous force network in 3D cellularized collagen networks

Study on the preparation of collagen-modified silk fibroin films and their properties.