Abstract:Abstract: Novel nanostructured iron oxide-reduced graphene oxide composites were synthesized by a facile one-step hydrothermal method in an ethylene glycol (EG)–water system. Different phases of iron oxides were detected by adjusting fabrication parameters including the EG/H2O ratio, base content and iron ions concentration. Electrochemical propertyof fabricated nanocomposites as anode material was examined in a coin–type cell. The high–rate capacity and cycling stability were found, which is attributed to the improved lithium storage capability due to the application of graphene sheet acting as conductive materials for iron oxide nanoparticles. This study provides a favorable approach for exploring the nanocomposites of metal oxide-graphene anode for lithium ion battery applications. Introduction: Currently,α–Fe2O3 has been considered as a promising candidate for lithium ion batteries due to its much higher theoretical capacity of 1350 mAhg‾1 than that of commercial graphite anode materials and its environmental friendly fabrication methods from low–cost resources [1]. In particular, the use of nanomaterials is an effective path to improve rate capabilities of solid state electrodes in batteries attributed to their relatively small diffusion lengths. Furthermore,graphene, with an excellent electronic conductivity, a high theoretical surface area of 2630 m2/g and superior mechanical properties, is a significantly promising component for high performance electrode materials [2]. In this study, an anode material of iron oxide nanoparticles (mainly α–Fe2O3)–reduced graphene oxide for lithium ion battery has been synthesized and reported. Experimental: FeCl3·6H2O (1.08 g) and NaOH (0.8 g) was dissolved in EG (30 ml) by ultrasonication for 1 hour.Then 10 ml deionized water and 15 mg graphene oxide was added to the mixture under stirring to get a homogeneous solution. The solution was transferred into a 50 ml teflon–lined stainless steel autoclave, sealed and heated at 200oC for 10 hours. The product was collected by centrifuging and washed by ethanol and deionized water alternatively for several times, which was followed by drying at 80oC. Morphologies and phases of synthesized nanocomposites were characterized by scanning electron microscopy (SEM), Raman scattering spectroscopy, X-ray diffraction (XRD), high resolution transmission electron microscopy(TEM). Results: Typical XRD pattern of the products was illustrated in Fig.1 that demonstrated the co–existence of α–Fe2O3 and Fe3O4. Diffraction peaks can be indexed to either the rhombohedral phase of α-Fe2O3 (JCPDS NO.84-0307) or the cubic phase of Fe3O4 (JCPDS NO.65-3107). The characteristic peak of graphene oxide located at 10.4° was not found, confirming the formation of graphene. Fig. 1 also showed the SEM image of fabricated iron oxide nanoparticles that were uniform with the diameter about 50 nm, indicating XRD pattern in good agreement with SEM results. Raman spectra also confirmed that the typical features of reduced graphene oxide with the presence of D band (1348 cm−1) and G band (1598 cm−1). References: [1] P. C. Wang, H. P. Ding, Tursun Bark, and C. H. Chen, Electrochimica Acta,52 (2007) 6650–6655 [2] S. Stankovich, D. A. Dikin, G. H. B. Dommett, K.M. Kohlhaas, E. J. Zimney, E. A. Stach, R. D. Piner, S.T. Nguyen, and R.S. Ruoff, Nature, 442 (2006) 282–286

Reduction of Graphite Oxide Using Alcohols

A Simplified Chemical Reduction Method for Preparation of Graphene: Dispersity, Reducibility and Mechanism

Promotional Synergistic Effect of Sn Doping into a Novel Bimetallic Sn-W Oxides/graphene Catalyst for Selective Oxidation of Alcohols Using Aqueous H2O2 Without Additives

Supercapacitors Based on Low-Temperature Partially Exfoliated and Reduced Graphite Oxide

Effective reduction of graphene oxide thin films by a fluorinating agent: Diethylaminosulfur trifluoride

Efficient Reduction and Exfoliation of Graphite Oxide by Sequential Chemical Reduction and Microwave Irradiation

Reduction of Graphene Oxide in Li-ion Batteries

Graphitization with Suppressed Carbon Loss for High-Quality Reduced Graphene Oxide

Nanocomposite of Iron Oxide-Reduced Graphene Oxide Applied As High-Performance Anode Materials for Lithium Ion Batteries

Customizing oxygen–containing functional groups for reduced graphene oxide film supercapacitor with high volumetric performance

Liquid-phase and Solid-Phase Microwave Irradiations for Reduction of Graphite Oxide

Highly Efficient Preparation of Graphite Oxide without Water Enhanced Oxidation

Solvent-Assisted Thermal Reduction of Graphite Oxide

A New Reducing Agent to Prepare Single-Layer, High-Quality Reduced Graphene Oxide for Device Applications

Highly efficient restoration of graphitic structure in graphene oxide using alcohol vapors.

Low-Temperature Aluminum Reduction of Graphene Oxide, Electrical Properties, Surface Wettability, and Energy Storage Applications

Synthesis Of Graphene Nanosheets Via Oxalic Acid-Induced Chemical Reduction Of Exfoliated Graphite Oxide

Microfluidic Oxidation of Graphite in Two Minutes with Capability of Real‐Time Monitoring

An Efficient and Eco‐friendly Solution‐chemical Route for Preparation of Ultrastable Reduced Graphene Oxide Suspensions

A Facile and Cost-Effective Approach to the Reduction of Exfoliated Graphite Oxide Using Sodium Hypophosphite under Acidic Conditions

A Facile Approach to Prepare Graphene Via Solvothermal Reduction of Graphite Oxide