Photocatalytic Reduction of Nitrate over Chalcopyrite CuFe 0.7 Cr 0.3 S 2 with High N 2 Selectivity

Rong Wang,Mufei Yue,Rihong Cong,Wenliang Gao,Tao Yang
DOI: https://doi.org/10.1016/j.jallcom.2015.08.182
IF: 6.2
2015-01-01
Journal of Alloys and Compounds
Abstract:Photocatalytic reduction of nitrate (NO3-) is a green and potentially inexpensive technique for reducing NO3- pollution in ground water. TiO2-based photocatalysts have been studied extensively for this purpose. In the present study, the semiconducting catalyst CuFe0.7Cr0.3S2 was applied to NO3- reduction. Loading this catalyst with metal co-catalysts (Ru, Au, Cu, Ag, Pt, and Pd) greatly increased the rate of NO3- reduction and the N-2 selectivity. In addition, there was a synergistic enhancement of the photocatalytic performance when the catalyst was loaded two co-catalysts. For example, the catalyst loaded with Pd and Au at mass fractions of 0.75% and 3%, respectively, could photocatalyze the complete reduction of NO3- in a 100 ppm N aqueous solution with 100% N-2 selectivity in less than 5 h with UV irradiation. However, with an inner irradiation from a full-arc Xe lamp, the NO3- conversion rate reduced to 0.065 mg N/h, probably because of the low density of the photoexcited electrons. The results show the potential of metal sulfides for photocatalytic reduction of NO3-, and the possibility of use of visible light. (C) 2015 Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?