Abstract:During the grain drying process, in order to adjust the temperature, it is necessary to match the proportion of hot and cold air. This is the problem that the two components in the mixed gas cannot fully mix with each other in a short period of time, resulting in the problem that it takes a long time for the gas flow temperature to reach a stable value. Based on the process and technical requirements of the dryer, a self-priming hot air temperature changing device suitable for the dryer was designed. The two gas components used to improve the variable temperature ratio of the dryer are fully mixed with each other in a short time and a short distance, thereby reducing the loss caused by the food not reaching safe moisture. Based on Bernoulli's principle and the basic theory of airflow mixing in fluid dynamics, a mathematical model of airflow mixing in the constriction section of the main pipeline was established. Fluent was used to numerically simulate the distribution of uniform mixing distance and temperature field in the necking section. The results show that the mixing uniformity in the necking section reaches 75%-80%, which effectively improves the mixing efficiency. A self-priming hot air temperature change device test bench developed independently was used, and the quadratic orthogonal rotation combined test method was used for parameter optimization. Design-Expert.V8.0.6.1 was used for analysis and testing, and the regression equation and response surface were obtained to analyze the effects. Interaction between factors to determine the best combination of optimization parameters: when the number of air inlet pipes is 3.16, the incision axial angle is 27.6°, the temperature difference is 43.5°C, and the pipe diameter is 23.8mm, the post-mixing temperature is 50.93°C, and the mixing distance is uniform is 39.33mm. The test results are consistent with the optimization results. The self-priming hot air temperature changing device of the dryer has certain practical application value.

Kinematic Simulation and Experimental Study on Rotating Air Flow for Drying Alfalfa

Optimal Design of an Angular Box for a Mixed Flow Grain Dryer

Performance Simulation of a Modified Geothermal Grain Dryer Based at Menengai Well 3 in Kenya

Experimental and numerical study of the airflow distribution in mixed-flow grain dryers

The simulation analysis and experiment of drying thin-layer radish strips

Analysis and structure optimization of the flow and temperature fields of the large-scale hot air drying room

A Simulation Study of Heat and Mass Transfer in A Honeycombed Rotary Desiccant Dehumidifier

DESIGN AND EXPERIMENTAL VERIFICATION OF SELF-PRIMING HOT AIR TEMPERATURE CHANGING DEVICE FOR GRAIN DRYER

Flow field analysis and design optimisation of Tibetan medicine double heat pump drying room

Modelling of Airflow Circulation Systems in Wood Drying Processes

Simulation and Optimization Experiment: Working Process of a Cleaning Device for Flax Combine Harvester

Calibration and test of contact parameters for alfalfa stalk at primary florescence based on discrete element method

Study on Numerical Simulation of Airflow Distribution in Hot Pump Drying Room of Peppercorns

STUDY OF THE MECHANICAL IMPACT ON ALFALFA SEEDS IN THE SEEDER TUBE OF A SEEDER ON THE BASIS OF A DIGITAL TWIN

Investigation on airflow distribution under different feed thickness combined CFD modeling and experimental verification

Simulation of structural dynamics of forage grass of alfalfa based on dual-scale automation

Researching of Airflow Circulation System in Wood Drying Kiln Based on Array Fans

SIMULATION OF BIOMASS DRYING IN A DIRECT CONTACT ROTARY DRYER

Theoretical and experimental research on heat and mass transfer in a turbine thin layer dryer

Numerical investigation of airflow and heat transfer characteristics and optimal design of the American ginseng drying room

Optimal lamella geometry for mixed flow dryers