Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Ab Initio Investigation of Structural, Electronic, Mechanical, and Thermodynamic Properties of Alsc2 Intermetallic Compound under Pressure

Ab Initio Calculation of Structure and Thermodynamic Properties of Zintl Aluminide SrAl2

First-principles investigation of mechanical, electronic and optical properties of Al 3 Sc intermetallic compound under pressure

The first-principles calculations for the elastic properties of Zr2Al under compression

First-principles investigations of structural, mechanical, electronic and optical properties of U3Si2-type AlSc2Si2 under high pressure

The Mechanical and Thermodynamic Properties of Heusler Compounds Ni2xal (X = Sc, Ti, V) under Pressure and Temperature: A First-Principles Study

First Principle Study on Electronic, Thermophysical and Optical Properties of ScAl3C3 and UAl3C3 under High Pressure

First-principles Calculations to Investigate Mechanical, Thermodynamic and Electronic Properties of Al2CuMg Intermetallic Compound under Pressure Effect

Ab initio study of AlCu2M (M = Sc, Ti and Cr) ternary compounds under pressures

Structural, Electronic, Elastic and Thermodynamic Properties of Caal2zn2 Compound under Different Pressures

First-principles Investigation of the Structural, Mechanical and Thermodynamic Properties of Al2Cu Phase under Various Pressure and Temperature Conditions

High pressure studies of sc based ternary system: a DFT study

Pressure Effects on Elastic and Thermodynamic Properties of Zr3al Intermetallic Compound

First-principles Investigations on Structural, Elastic, Thermodynamic and Electronic Properties of Ni3X (X = Al, Ga and Ge) under Pressure

First-principles Study of Ni-Al Intermetallic Compounds under Various Temperature and Pressure

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Structural, Mechanical, Thermal and Electronic Properties of Novel Ternary Carbide Al4si2c5 under High Pressure by Dft Calculation

Physical properties and Debye temperature of Al7Cu2Fe alloy under various pressures analyzed by first-principles

First-principles Investigation on the Elastic Stability and Thermodynamic Properties of Ti 2 SC

Electronic Structure, Phase Transition, and Elastic Properties of ScC under High Pressure

First-Principles Investigation of Thermodynamic, Elastic and Electronic Properties of Al3v and Al3nb Intermetallics under Pressures