Abstract:Shear-mode piezoelectric materials have been widely used to shunt the damping of vibrations where utilizing surface or interface shear stresses. The thick-shear mode (TSM) elastic constant and the mechanical loss factor can change correspondingly when piezoelectric materials are shunted to different electrical circuits. This phenomenon makes it possible to control the performance of a shear-mode piezoelectric damping system through designing the shunt circuit. However, due to the difficulties in directly measuring the TSM elastic constant and the mechanical loss factor of piezoelectric materials, the relationships between those parameters and the shunt circuits have rarely been investigated. In this paper, a coupling TSM electro–mechanical resonant system is proposed to indirectly measure the variations of the TSM elastic constant and the mechanical loss factor of piezoelectric materials. The main idea is to transform the variations of the TSM elastic constant and the mechanical loss factor into the changes of the easily observed resonant frequency and electrical quality factor of the coupling electro–mechanical resonator. Based on this model, the formular relationships are set up theoretically with Mason equivalent circuit method and they are validated with finite element (FE) analyses. Finally, a prototype of the coupling electro–mechanical resonator is fabricated with two shear-mode PZT5A plates to investigate the TSM elastic constants and the mechanical loss factors of different circuit-shunted cases of the piezoelectric plate. Both the resonant frequency shifts and the bandwidth changes observed in experiments are in good consistence with the theoretical and FE analyses under the same shunt conditions. The proposed coupling resonator and the obtained relationships are validated with but not limited to PZT5A.

Electromechanical Properties of Thin Strip Piezoelectric Vibrators at High Frequency

High-Damping Viscoelastic Material Monitoring Using Sub-Resonator Enhanced Electro-Mechanical Impedance Spectroscopy

Characterization of Piezoelectric Materials Using Ultrasonic and Resonant Techniques

Investigation of High-Power Properties of PIN-PMN-PT Relaxor-Based Ferroelectric Single Crystals and PZT-4 Piezoelectric Ceramics.

Fabrication and modeling of piezoelectric transducers for High-Frequency medical imaging

Frequency Dependent Properties Of High Permittivity Pmnt Piezoelectrics For Ultrasonic Transducer Applications

Investigations of Thickness-Shear Mode Elastic Constant and Damping of Shunted Piezoelectric Materials with a Coupling Resonator

Finite element method simulation, design, and fabrication of micromachined high-frequency piezoelectric composite with hexagonal pillars for intravascular ultrasound imaging

Acoustic and Electromagnetic Co-Modeling of Piezoelectric Devices at Millimeter Wave

Design, fabrication, and evaluation of high frequency, single-element transducers incorporating different materials

High-field complex parameters characterization of PMN-PT single crystal/epoxy 1–3 composites ( φ = 0.4) under a high AC electric field with a varied intensity

High Voltage Excitation And Nonlinear Transmission Of A 16 Mhz Aln-Based Piezoelectric Micro-Machined Ultrasonic Transducer

Analysis of Flexural Vibrations of a Piezoelectric Semiconductor Nanoplate Driven by a Time-Harmonic Force

Development of a High-Power Testing System for Piezoelectric Ceramic Material

The Field And Frequency Dependence Of The Strain And Polarisation In Piezoelectric And Electrostrictive Ceramics

Characterization of High-Field Properties of 0.28PIN-0.42PMN-0.30PT Single Crystal/epoxy 1–3 Composite for Acoustic Transducer Applications

High-Frequency Vibration Analysis of Piezoelectric Array Sensor under Lateral-Field-Excitation Based on Crystals with 3 M Point Group.

Elastic and Piezoelectric Properties of Piezoelectric Composite Materials

The electromechanical coupling property and vibration behavior in 1-3 type piezoelectric composites

Characterization of Full Set Material Constants and Their Temperature Dependence for Piezoelectric Materials Using Resonant Ultrasound Spectroscopy