Surface Layer in Relaxor Ferroelectric Pzn-4.5%Pt Single Crystals

W. S. Chang,M. Shanthi,K. K. Rajan,L. C. Lim,F. T. Wang,C. T. Tseng,C. S. Tu,Ping Yang,H. O. Moser
DOI: https://doi.org/10.1063/1.2749199
IF: 2.877
2007-01-01
Journal of Applied Physics
Abstract:The origin of the extremely broad peak at the lower 2θ side of the main (002) rhombohedral x-ray peak in an unpoled (001)-cut Pb(Zn1/3Nb2/3)0.955Ti0.045O3 (PZN-4.5%PT) single crystal has been examined. This peak, located at about 2θ∼43°–44°, was absent on fractured surfaces of the crystal but reappeared when the fractured surfaces were polished mechanically. High-resolution synchrotron x-ray mesh scans revealed that the as-polished surface was covered with a “deformed layer” of heavily stressed rhombohedral phase of monoclinic symmetry having its c axis lying perpendicular to the surface. This deformed phase can be structurally likened to one full of “incipient monoclinic nuclei/phases,” which are microscopic in size and subject to intense compression in the plane of the surface. With a given polishing direction, this surface layer showed parallel domain patterns when viewed under the polarized light microscope. This surface layer could be largely eliminated by appropriate poling at 0.7–1.5 kV/mm at room temperature but became resistant to poling after annealing.
What problem does this paper attempt to address?