Abstract:Thermal effects are the main obstacle for side-pumped direct-liquid-cooled Nd: YAG thin-disk lasers (SDNTDLs) to achieve high-power near-diffraction-limited laser output. A multiphysics model is established and several basic understandings are obtained. The temperature distribution of the disk under lateral non-uniform pumping shows that the total reflection transmission of the pump lights in the disk does not result in severe temperature fluctuations. The thickness of the thermal boundary layer is much less than half the thickness of the fluid, indicating that there is no thermal interaction between two adjacent disks. The component analysis of the thermally-induced wavefront aberration (TIWA) reveals that the influence of the fluid's thermo-optic effect (TOE) which is awful in liquid lasers is not necessarily dominant in SDNTDLS due to the thin thermal boundary layer. When cooled by D 2 O, the wavefront aberration induced by the disk is much larger than that induced by the fluid. As a result, the TIWA exhibits a distribution of high at both sides and low at the center along the transverse direction of the disk, which is consistent with the experimental results. The wavefront aberration induced by the fluid's TOE and that induced by the disk's both TOE and deformation compensate for each other, indicating that the beam quality can be significantly improved by means of design optimization.

A Modified Model for the LD Pumped 2μm Tm:YAG Laser: Thermal Behavior and Laser Performance

Modeling of Kinetic and Thermodynamic Processes in a Flowing Exciplex Pumped Alkali Vapor Laser

Theoretical Analysis of Thermal-Lensing Effect in a High Power Exciplex Pumped Cs Vapor Laser.

Modeling of Steady-State Temperature Distribution in Diode-Pumped Alkali Vapor Lasers: Analysis of the Experimental Results

Three-Dimensional Kinetic and Fluid Dynamic Modeling and Three Iterative Algorithms for Side-Pumped Alkali Vapor Lasers

Thermal Effects in High-Power Double Diode-End-Pumped Cs Vapor Lasers

Modeling of Three-Dimensional Exciplex Pumped Fluid Cs Vapor Laser with Transverse and Longitudinal Gas Flow

Modeling of a Diode Side Pumped Cesium Vapor Laser MOPA System

Analysis of temperature distributions in diode-pumped alkali vapor lasers

Theoretical Design and Experimental Research on High Power Yb∶ YAG Ceramic Slab Laser Amplifier

Modeling of End-Pumped CW Yb:YAG Lasers Exhibiting Non-Uniform Temperature Distribution

Simulation and Analysis of the Time Evolution of Laser Power and Temperature in Static Pulsed XPALs

Analysis of Thermal Effects in A Pulsed Laser Diode End Pumped Single-Ended Composite Tm:Yag Laser

Thermal Effects Analysis of High-Power Slab Tm:YLF Laser with Dual-End-Pumped Based on COMSOL Multiphysics

Q-Switched Operation of End-Pumped Yb : Yag Lasers with Non-Uniform Temperature Distribution

Numerical Analysis of Temperature Distributions in Yb-Doped Double-Clad Fiber Lasers with Consideration of Radiative Heat Transfer

Temperature and Thermal Stress Distribution in Thin Disk Laser End-Pumped by LD

Research of Quasi-Three-Level Thermal Effect of Diode-Pumped Tm: Yag Crystal

Thermal analysis of side-pumped direct-liquid-cooled Nd: YAG thin-disk lasers

Modeling of Pulsed Cs Vapor Lasers in Transversely Pumped Configuration

Four-Dimensional Thermal Analysis of 888 Nm Pumped Nd:Yvo4 Dual-Rod Acousto-Optic Q-Switched Laser