Abstract:Wireless electromagnetic sensing is a passive, non-destructive technique for measuring physical and chemical changes through permittivity or conductivity changes. However, the readout is limited by the sensitivity of the materials, often requiring complex sampling, particularly in the GHz range. We report capacitive dielectric temperature sensors based on polydimethylsiloxne (PDMS) loaded with 10 vol% of inexpensive, commercially available conductive fillers including copper powder (Cu), graphite powder (GP) and milled carbon fibre powder (CF). The sensors are tested in the range of 20°C to 110°C, with enhanced sensitivity from 20 to 60°C, and relative response of up to 85.5% at 200 MHz for CF loaded capacitors. Additionally, we demonstrate that operating frequency influences the relative sensing response by as much as 15.0% in loaded composite capacitors. Finally, we demonstrate the suitability of PDMS-CF capacitors as a sensing element in wirelessly coupled chipless resonant coils tuned to 6.78 MHz with a readout response, in the resonant frequency of the sensor. The wireless readout of the PDMS-CF chipless system exhibited an average sensitivity of 0.38 %°C-1 which is a 40x improvement over a pristine PDMS-based capacitive sensor and outperforms state of the art frequency-domain radio frequency (RF) temperature sensors including carbon-based composites at higher loadings. Exploiting the high sensitivity, we interrogate the sensor wirelessly using a low-cost and portable open-source NanoVNA demonstrating a relative response in the resonant frequency of the reader coil of 48.5%, with the response in good agreement with the instrumentation-grade vector network analyzers (VNAs), demonstrating that the sensors could be integrated into an inexpensive and portable measurement setup that does not rely on specialty equipment or highly trained operators.

Low Dielectric Loss Polymer-Ceramic Composites for Wireless Temperature Sensation

Ceramic-Polymer Composites with Low Dielectric Loss for Microwave Antennas and Wireless Sensors

A New HDPE/BST Polymer–ceramic Composite for Wireless Temperature Sensing

Low-temperature Co-Fired Ceramics with High Thermal Expansion and Reliability for Millimeter-Wave Antennas

Highly Sensitive Temperature Sensor Using Intrinsic Mach-Zehnder Interferometer Formed by Bent Micro-Fiber Embedded in Polymer

Thermally Stable Polymer–ceramic Composites for Microwave Antenna Applications

New Three-Phase Polymer-Ceramic Composite Materials for Miniaturized Microwave Antennas

Large-Area Conductor-Loaded PDMS Dielectric Composites for High-Sensitivity Wireless and Chipless Electromagnetic Temperature Sensors

Dielectrically-Loaded Cylindrical Resonator-Based Wireless Passive High-Temperature Sensor

Temperature-dependent dielectric properties, thermally-stimulated relaxations and defect-property correlations of TiO2 ceramics for wireless passive temperature sensing

e temperature coe ffi cient behavior of the high-density polyethylene composites with multi-dimensional carbon fi llers and their use for temperature-sensing resistors †

Modified poly(phenylene oxide)/(CaSr)TiO 3 composites with ultrahigh permittivity and low loss for microwave substrates

Surface-modified Li3Mg2NbO6 ceramic particles and hexagonal boron nitride sheets filled PTFE composites with high through-plane thermal conductivity and extremely low dielectric loss

Dielectric response of Mg 0.95 Ca 0.05 TiO 3 ceramic filled HDPE composites with low dielectric loss

Inhibition conduction loss for distinct improvement of energy storage density over a broad temperature range in polyetherimide-based composite films

Enhanced positive temperature coefficient behavior of the high-density polyethylene composites with multi-dimensional carbon fillers and their use for temperature-sensing resistors

An UHF band planar resonator temperature sensor constructed from high-performance titanium dioxide system microwave dielectric ceramics: Toward integrated ceramic-based sensor devices

Surface-modified Zn0.5Ti0.5NbO4 particles filled polytetrafluoroethylene composite with extremely low dielectric loss and stable temperature dependence

Electromagnetic wave absorption of polymer derived ceramic composites tuned by multi-component oxide solid solution

Uhf Rfid Temperature Sensor Tag Using Novel Hdpe-Bst Composite Material

Co-substituted CuO–ZrO2–Nb2O5 composite ceramics with low-temperature sintering and low-loss for high-performance patch antenna