Abstract:In the present work, three different scratch tests are compared on their ability to rank the abrasion resistance of low alloy steels for industrial applications where the abrasion play a key role, e.g., in earthmoving, agricultural and mining equipment. The first test involves single pass scratching of pristine surfaces with a relatively large rigid indenter. The second test involves multi-pass scratching along a fixed track using the same large indenter. The third test involves the creation of a multi-pass scratch track using the same large indenter followed by final scratching of the abrasion track with a sharp indenter, i.e., Multi-Pass Dual Indenter (MPDI) scratch test. The three test protocols activate different abrasion mechanisms. Five low alloy construction steel grades with different strain hardening capabilities, i.e., Interstitial-free Ferritic steel (IF steel), Fully Martensitic steel (FM steel), Dual Phase steel (DP steel), Quench Partitioning steel (Q&P steel) and TWining Induced Plasticity steel (TWIP steel), are used. The results show that for both single (large) indenter scratch test protocols, the scratch depths always increase with indenter load and the failure mechanism is pure ploughing except for the IF steel due to the nature of softness. While for the dual-indenter scratch test, the scratch depth is a more complex function of the load applied during creation of the work hardened surface layer. The conventional scratch test protocols cannot well reveal micro-cracks and defect in (sub) surface and cannot well reflect the real response of strain hardening of steels. However, the MPDI test can distinguish between different steels with different initial hardness and different strain hardening behaviour and reveal the damage and, equally important, can indicate how average loading conditions may affect the relative abrasion resistance of construction steels during steady state conditions.

Prediction of the Abrasion Resistance of Construction Steels on the Basis of the Subsurface Deformation Layer in A Multi-Pass Dual-Indenter Scratch Test

A novel multi-pass dual-indenter scratch test to unravel abrasion damage formation in construction steels

Abrasion Resistance Characterization of Low Alloy Construction Steels: A Comparison Between Three Different Scratch Test Protocols

The effect of ferrite–martensite morphology on the scratch and abrasive wear behaviour of a dual phase construction steel

Depth-Sensing Indentation-Based Studies of Surface Mechanical Behavior and Fatigue Damage Evolution of an Austenitic Stainless Steel Subjected to Cyclic Straining

The Scratch and Abrasive Wear Behaviour of A Tempered Martensitic Construction Steel and Its Dual Phase Variants

The Effect of Martensite Volume Fraction on the Scratch and Abrasion Resistance of a Ferrite–martensite Dual Phase Steel

A Study on Correlating Microstructural Features with Abrasion Resistance of a High Strength Low Alloy Steel

Damage Mechanisms of Material in Single-Cone Scratching

Wear Conditions-Dependent Tribological Behavior in Q&P Medium-Mn Steels: the Role of TRIP Effect and Strain Hardening

Understanding and quantification of elastic and plastic deformation during a scratch test

Design of Low Hardness Abrasion Resistant Steels

Micro-characterization of macro-sliding wear for steel

A 3D multi-scratch test model for characterizing material removal regimes in 5083-Al alloy

Abrasive and adhesive wear behaviour of metallic bonds in a synthetic slurry test for wear prediction in reinforced concrete

A novel method for competitive failure behavior and mechanical degradation online monitoring of laser additive work roll under multidimensional damage

Effect of hardenability on microstructure and property of low alloy abrasion-resistant steel

Abrasive Wear Mechanisms in Steels

The effect of hardness on the transition of the abrasive wear mechanism of steels

Deformation Behavior of Alloys Based on Iron and Manganese in Scratch, Tensile, and Indentation Tests

Recatest—A Technique for Qualitative and Quantitative Assessment of Deferment and Degraded PVD Coatings and CVD Layers in the Deformed Area in the Scratch Test