Abstract:Phased array ultrasonic testing (PAUT) based on full matrix capture (FMC) has recently been gaining popularity in the scientific and nondestructive testing communities. FMC is a versatile acquisition method that collects all the transmitter-receiver combinations from a given array. Furthermore, when postprocessing FMC data using the total focusing method (TFM), high-resolution images are achieved for defect characterization. Today, the combination of FMC and TFM is becoming more widely available in commercial ultrasonic phased array controllers. However, executing the FMC-TFM method is data-intensive, as the amount of data collected and processed is proportional to the square of the number of elements of the probe. This shortcoming may be overcome using a sparsely populated array in transmission followed by an efficient compression using compressive sensing (CS) approaches. The method can therefore lead to a massive reduction of data and hardware requirements and ultimately accelerate TFM imaging. In the present work, a CS methodology was applied to experimental data measured from samples containing artificial flaws. The results demonstrated that the proposed CS method allowed a reduction of up to 80% in the volume of data while achieving adequate FMC data recovery. Such results indicate the possibility of recovering experimental FMC signals using sampling rates under the Nyquist theorem limit. The TFM images obtained from the FMC, CS-FMC, and sparse CS approaches were compared in terms of contrast-to-noise ratio (CNR). It was seen that the CS-FMC combination produced images comparable to those acquitted using the FMC. Implementation of sparse arrays improved CS reconstruction times by up to 11 folds and reduced the firing events by approximately 90%. Moreover, image formation was accelerated by 6.6 times at the cost of only minor image quality degradation relative to the FMC.

Accelerated Air-Coupled Ultrasound Imaging of Wood Using Compressed Sensing

An air-coupled ultrasonic imaging system for non-destructive wood testing

Dual-compressed Photoacoustic Single-Pixel Imaging

Single-Shot Compressed Photoacoustic Tomographic Imaging with a Single Detector in a Scattering Medium

Spatial-frequency parallel subsampling for distributed compressive sensing in ultrasonic imaging inspection

Compressed Sensing For High Frame Rate, High Resolution And High Contrast Ultrasound Imaging

Compressed Sensing Photoacoustic Imaging for High-Speed Imaging with Sparse Measurement: a Theoretical Study

Compressed Sensing in Photoacoustic Tomography in Vivo

Compressive‐sensing Swept‐source Optical Coherence Tomography Angiography with Reduced Noise

Review of the Use of Air-Coupled Ultrasonic Technologies for Nondestructive Testing of Wood and Wood Products

Virtual Compressed Sensing Photoacoustic Tomography with High-Detection Efficiency Using K-Wave

An improved measurement matrix of compressed sensing for synthetic aperture ultrasound imaging

Ultrasound Plane-Wave Compressed Sensing Reconstruction Method Using Intra-frame and Inter-frame Joint Multi-hypothesis and Reference Frame Multi-hypothesis Predictions

A Compressed Sensing Strategy for Synthetic Transmit Aperture Ultrasound Imaging

Compressive Sensing Strategy on Sparse Array to Accelerate Ultrasonic TFM Imaging

Defect Detection in Solid Timber Panels Using Air-Coupled Ultrasonic Imaging Techniques

Hardware-Enabled Compressed Sensing Method for Ultrasonic Images in Logging While Drilling

Compressed Sensing for Full Matrix Capture Data Based on Optimal Reconstruction Algorithm

The Application of Compressed Sensing Method in Photoacoustic Image Reconstruction

Fast High-Quality Sparse Reconstruction of Photoacoustic Imaging Based on HTP Compressed Sensing

Fast-detection Photoacoustic Tomography Platform Based on GPSR Compressed Sensing