Determination of fracture toughness of amorphous carbon coatings using indentation method
S. M. Rasel,Y. Q. Wang,H. K. Ku,J. M. Byeon,T. K. Kim,J. I. Song
2011-01-01
Abstract:Fracture toughness is the ability of a material to resist the growth of a preexisting crack. Toughness encompasses the energy required both to create the crack and to enable the crack to propagate until fracture, whereas fracture toughness takes only account of the energy required to facilitate the crack propagation to fracture. For bulk materials and some thick films, fracture toughness is easily measured according to ASTM standards [1]. However, for thin films, fracture toughness measurement remains difficult because of the thickness limitation [2]. Thin coatings have become a key technology in a wide range of industries for a vast range of engineering purposes. The successful performance and reliability of thin coatings is often limited by their mechanical properties. Generally, harder coatings are more brittle and easily damaged by shock loads in practical applications. A necessary criterion for evaluating brittleness of thin coatings is to measure fracture toughness of the coatings. Unlike the bulk materials, however, until now, there is neither standard procedure nor commonly accepted methodology to follow. Amorphous carbon coatings, often called diamondlike carbon (DLC) coatings, have lots of interesting properties such as very high hardness and elastic modulus, high electric resistivity, high optical transparency and chemical inertness, which are close to those of diamond [3, 4]. These coatings have a wide range of uses including optical, electronic, thermal management (heat sinks), biomedical and tribological applications. In certain applications, there is a need for thin coatings to improve friction and wear performance. Intensive research has been done on the measurement of hardness and elastic modulus of such thin DLC coatings deposited by different deposition techniques [5-8]. However, very little is understood on their fracture toughness. The objective of this study was to deposit a thin coating of DLC on a ceramic substrate by plasma-enhanced chemical vapor deposition (PECVD) via evaluating their fracture toughness using micro Vickers’s indenter based on the energy release.