Abstract:Two-phase flows are common phenomena in numerous industrial equipment. The complex and changeable phase interface determines the characteristics such as flow pattern evolution and energy-mass transport between the two phases. As a key component of rod bundle fuel assembly in nuclear reactors, the spacer grid plays important roles, including fixing the rod position, promoting mixing, and intensifying heat transfer. This study investigated the axial two-phase flow evolution and interfacial area transport characteristics downstream of the non-mixing vane spacer grid (N-MVSG) inside a tight lattice rod bundle fuel assembly under air-water two-phase flows. A self-developed double-layer wire-mesh sensor (WMS) was adopted to survey 6 positions downstream of the N-MVSG ( Z / D h = 9.15, 14.94, 20.73, 26.52, 32.31, and 61.26), and 42 cases were acquired from bubbly to cap-bubbly and to slug flow. Eventually, void fraction, bubble velocity, interfacial area concentration (IAC), and bubble size distribution (BSD) databases were established. Under the group-1 (G-1) flow, some small bubbles migrate toward the subchannel center, and the void fraction gap-region peak distribution gets weakened. The 1-D void fraction and IAC after the N-MVSG increase first and then gradually recover to its upstream level. Under the two-group flow, the N-MVSG clearly cut group-2 (G-2) bubbles, and the time-averaged void fraction profile downstream of N-MVSG undergoes the evolution of the square distribution, and ring distribution, and then reverts to the upstream core peak distribution. The analysis of BSD results indicates that the G-2 bubbles' break-up is mainly caused by the increment of the flow-field turbulence, rather than the cutting of the N-MVSG. The 1-D void fraction and IAC transport show the total void fraction and IAC increase first and then recover downstream of the N-MVSG. Meanwhile, the G-2 void fraction and IAC reach the maximum before the G-1's due to the coalescence of the G-1 and G-2 bubbles at the N-MVSG's exit. The model evaluation using the IATE without bubble interaction source/sink terms shows that, for most cases, the advection effect and pressure effect dominate the void fraction and IAC evolution. The remarkable bubbles' break-up occurs under the transition cases and the two-group cases with high liquid velocity. In future studies, the additional source/sink term models considering the N-MVSG effect should be developed based on these cases to improve the IATE prediction performance.

Direct observation of single- and two-phase flows in spacer filled membrane modules

Experimental Investigation of Flow Development in Large-Scale Bubble Columns in the Churn-Turbulent Regime

Direct Observation of Flow and Bubble Behavior in Flat Sheet Modules with a Distributor

n of fl ow and bubble behavior in fl at sheet modules with a distributor

EFFECTS OF INLET ARRANGEMENTS ON LIQUID-LIQUID FLOW PATTERNS IN CROSS-JUNCTION SQUARE MICROCHANNELS

CFD simulations of different spacer geometries in plate-and-frame modules

Measurements of liquid film and droplets of annular two-phase flow on a rod-bundle geometry with spacer

Study of spacer structure on the enhancement of heat and mass transfer in direct contact membrane distillation modules

Of annular two-phase flow on rod-bundle geometry with spacer

Cfd Simulations of the Fluid Flow Behavior in A Spacer-Filled Membrane Module

Experimental Investigation on Submerged Gas-Liquid Mixture Injection into Water Through A Micro-Channel

Two-phase flow evolution and interfacial area transport downstream of the non-mixing vane spacer grid in rod bundle channels

Impact of non-Newtonian fluid behavior on hydrodynamics and mass transfer in spacer-filled channels

In situ exploring the dynamic behaviors of gas bubbles in liquid by using a tapered dual-hole hollow fiber

Bubble Generation in a 3-D Flow-Focusing Microchannel: from Squeezing to Jetting

Experimental Study of Bubble Behaviour in a Flowing Liquid Layer

Static Mixing Spacers for Spiral Wound Modules

A computational fluid dynamics study on TPMS-based spacers in direct contact membrane distillation modules

Taylor bubble splitting, flow and coalescence in branching microchannels: An experimental and numerical simulation study

New Bubbles Behavior and Flow Pattern Transition of Open Micro-Channel and Jet Impingement Hybrid Cooling Scheme by Separating Liquid-Vapour Pathways

Flow behaviors of multiscale bubbles with porous ceramic membrane distributors: Visualization and modeling