Evaluation of Soil Erosion and Sediment Control Products for Release of Heavy Metals

Youxian Wu,Li Yang,Fatih Bueyueksoenmez,R. Edward Beighley,Zhimang Gu,Mark Grey
DOI: https://doi.org/10.1089/ees.2010.0149
IF: 2.1723
2010-01-01
Environmental Engineering Science
Abstract:Erosion and sediment control best management practices (BMPs) have been applied to construction sites since the U. S. EPA began regulating storm water discharges in 1987 under amendments to the Clean Water Act. Many BMPs are in use for the control of sediment and other nonpoint source pollutants. However, the chemical properties of these BMP products are not well characterized. These BMP products can have unintended adverse impacts on the environment. Therefore, the goals of this study were to determine the concentration of cadmium (Cd), copper (Cu), lead (Pb), and zinc (Zn) in 18 different soil erosion and sediment control BMPs and determine the short-term release potential of metals. Results show that the BMPs contained appreciable amount of heavy metals-Zn being the most prominent. Concentrations of heavy metals varied among the BMP products mostly in the range of 0-48 mu g/g. BMP products were ranked according to metal concentration from highest to lowest based on three categories: netting/blankets, hydraulic mulches, and sediment control products. Heavy metals released from sediment control products during 60-min leaching experiments accounted for 10%-19% of total Cd, 5%-30% of total Cu, 0%-9% of total Pb, and 0%-13% of total Zn. In addition, chemical additives (e. g., tackifiers) mixed with hydraulic mulch reduced the leaching potential of all heavy metals by 5%-50%. Results suggest that the BMP products can release considerable amounts of heavy metals and contribute to pollution; therefore, they should be carefully selected to ensure that their use does not result in an excursion from total maximum daily loads for metals in the site's receiving waters.
What problem does this paper attempt to address?