Abstract:Purpose Because many cutting fluids contain hazardous chemical constituents, industries and researchers are looking for alternative methods to reduce the consumption of cutting fluids in machining operations due to growing awareness of ecological and health issues, government strict environmental regulations and economic pressures. Therefore, the purpose of this study is to raise awareness of the minimum quantity lubrication (MQL) technique as a potential substitute for environmental restricted wet (flooded) machining situations. Design/methodology/approach The methodology adopted for conducting a review in this study includes four sections: establishment of MQL technique and review of MQL machining performance comparison with dry and wet (flooded) environments; analysis of the past literature to examine MQL turning performance under mono nanofluids (M-NF); MQL turning performance evaluation under hybrid nanofluids (H-NF); and MQL milling, drilling and grinding performance assessment under M-NF and H-NF. Findings From the extensive review, it has been found that MQL results in lower cutting zone temperature, reduction in cutting forces, enhanced tool life and better machined surface quality compared to dry and wet cutting conditions. Also, MQL under H-NF discloses notably improved tribo-performance due to the synergistic effect caused by the physical encapsulation of spherical nanoparticles between the nanosheets of lamellar structured nanoparticles when compared with M-NF. The findings of this study recommend that MQL with nanofluids can replace dry and flood lubrication conditions for superior machining performance. Practical implications Machining under the MQL regime provides a dry, clean, healthy and pollution-free working area, thereby resulting the machining of materials green and environmentally friendly. Originality/value This paper describes the suitability of MQL for different machining operations using M-NF and H-NF. Peer review The peer review history for this article is available at: https://publons.com/publon/10.1108/ILT-05-2023-0131/

The Effects of Minimum Quantity Lubrication (MQL) on Machining Force, Temperature, and Residual Stress

A comprehensive review of minimum quantity lubrication (MQL) machining technology and cutting performance

Influence of Minimum Quantity Lubrication Parameters on Tool Wear and Surface Roughness in Milling of Forged Steel

Predicting the Effects of Cutting Fluid on Machining Force, Temperature and Residual Stress Using Analytical Method.

Recent Progress on Lubricant Characteristics of Minimum Quantity Lubrication (MQL) Technology in Green Cutting

Investigation Of Cutting Force And Temperature Of End-Milling Ti-6al-4v With Different Minimum Quantity Lubrication (Mql) Parameters

CFD Analysis on the Flow Field of Minimum Quantity Lubrication During External Thread Turning

Recent developments in MQL machining of aeronautical materials: A comparative review

A New Approach to Predict Machining Force and Temperature with Minimum Quantity Lubrication

Predictive Modeling of Residual Stress in Minimum Quantity Lubrication Machining

Effect of Cutting Parameters on Minimum Quantity Lubrication Machining of High Strength Steel

Selection of Minimum Quantity Lubrication (MQL) Parameters in Milling of Ti-6Al-4V

Mechanism, cutting performance, and tool wear of MQL milling aluminum alloys with dual-nozzle

Cryogenic minimum quantity lubrication machining: from mechanism to application

Analytical modeling of residual stress in end-milling with minimum quantity lubrication

A review on minimum quantity lubrication (MQL) assisted machining processes using mono and hybrid nanofluids

The effects of minimum quantity lubrication parameters on the lubrication efficiency in the turning of plastic mold steel

A novel cooling and lubrication approach: Device development and machining performance evaluation of ultrasonic vibration–assisted MQL

Investigation on Surface Grinding of Ti-6Al-4V Using Minimum Quantity Lubrication

Numerical and Experimental Optimizations of Nozzle Distance in Minimum Quantity Lubrication (MQL) Milling Process

Effect of machining parameters in turning under different cooling conditions