Abstract:Abstract Over the past few years, the concept of multi-directional three-dimensional (3D) printing has been introduced to print complex shapes and overhang geometry. This technique requires the nozzle to constantly change orientation to print the object along its tangential direction. A six-degrees-of-freedom (6-DOF) robotic arm or Stewart platform can be a solution, but these mechanisms use more components and motors. An alternative solution has been proposed in this paper based on a four-CRU (cylindrical, revolute, and universal joints) mechanism. This mechanism can orient the nozzle by switching into different motion types with minimal numbers of motors while keeping the mechanism rigid and agile. Therefore, analyses of the reconfiguration, workspace, singularities, and self-motions of a four-CRU mechanism presented in this paper have become necessities. By using primary decomposition, four geometric constraints have been identified, and the reconfiguration analysis has been carried out in each of these. It reveals that each geometric constraint will have three distinct operation modes, namely Schönflies mode, reversed Schönflies mode, and an additional mode. The additional mode can either be a four-DOF mode or a degenerated three-DOF mode, depending on the type of geometric constraints. By taking into account the actuation and constraint singularities, the workspace of each operation mode has been analyzed and geometrically illustrated. It allows us to determine the regions in which the reconfiguration takes place. Furthermore, the inherent self-motion in the Schönflies mode is revealed and illustrated, which occurs at two specified actuated leg lengths. Demonstration of the reconfiguration process and self-motions is provided through a mock-up prototype.

Motion Generation of Planar Six- and Eight-Bar Slider Mechanisms As Constrained Robotic Systems

Dimensional Synthesis Of Planar Eight-Bar Linkages Based On A Parallel Robot With A Prismatic Base Joint

Dimensional Synthesis Of Planar Six-Bar Linkages By Mechanically Constrain A Prr Serial Chain

Deep Learning Conceptual Design of Sit-to-Stand Parallel Motion Six-Bar Mechanisms

Optimum design and analysis of a novel planar eight-bar linkage mechanism

The Synthesis of Planar Four-Bar Linkage for Mixed Motion and Function Generation

Type Synthesis of 2T1R Planar Parallel Mechanisms and Their Moduling Development Applications

Design and Analysis of Folding Mechanism for Intelligent Wheelchair-Stretcher Robot

Configuration design of movable heavy-duty reconfigurable posture adjustment platform with dual motion modes

Computer aided design of a single degree-of-freedom six-bar mechanism via Monte Carlo layered optimization method

Design Framework for Motion Generation of Planar Four-Bar Linkage Considering Clearance Joints and Dynamics Performance

Design and Kinematic Analysis of a Novel Planar Parallel Robot With Pure Translations

Structural–Parametric Synthesis of Single-Loop 6R and 7R Mechanisms Using Factorization of Motion Polynomials and Its Application in Grippers

Center-driven planar closed-loop mechanisms based on an angulated four-bar linkage

Using instantaneous invariants of the curvature theory in motion generation synthesis of 4R mechanisms with higher-order coupler point kinematics

Type synthesis of parallel mechanism with 3T/3R motion patterns

Design and analysis of a hexagon rolling mechanism with a center-arranged actuator

Geometric Constraint-Based Reconfiguration and Self-Motions of a Four-CRU Parallel Mechanism

Design and Motion Principle Analysis of new parallel mechanisms with fewer active inputs than the degrees of freedom

Type synthesis of a family of novel parallel leg mechanisms driven by a 3-DOF drive system

Kinematic design and analysis of a 6-DOF spatial five-Bar linkage