Abstract:Phenolic compound even at low concentrations, are considered to be priority pollutants due to their significant toxicity. Electrospinning was used to create a polyacrylonitril (PAN) nanofiber, which was then impregnated with graphene oxide (GO). After a preliminary investigation into the electrospinning parameters (e.g., using various voltages and polymer concentrations), the electrospun nanofibres were tuned, this study evaluated the effectiveness of these materials in removing phenolic compounds from wastewater through adsorption. Scanning electron microscopy (SEM) and Fourier transform infrared spectroscopy (FTIR) were used to analyze the synthesized nanofiber mats. The scanning electron microscopy (SEM) analysis revealed that the structure of nanofiber mats was altered by the addition of graphene oxide (GO) in different ratios. Specifically, the surface of the fibres exhibited increased roughness, and the diameter of the fibres also experienced an increase. The average diameter of the fibres was measured to be (134.9 ± 21.43 nm) for the PAN/2.5% GO composite and (198 ± 33.94 nm) for the PAN/5% GO composite. FTIR spectra of the PAN/GO nanocomposites nanofiber displayed distinct peaks associated with graphene oxide (GO). These included a wide peak at 3400 cm-1, related to the presence of hydroxyl (O-H) groups, as well as peaks on 1600 as well as 1000 cm-1, which indicated the existence of epoxy groups. In this study response surface methodology (RSM) was implemented. To enhance the efficiency of removing substances, it is necessary to optimise parameters such as pH, contact time, and dosage of the adsorbent. The optimum pH for removing phenol via all nanofiber mats was determined to be 7, while at a dose of 2 mg dose adsorbents maximum removals for pure PAN, PAN/2.5 GO, and PAN/5 GO were 61.3941, 77.2118, and 92.76139%, respectively. All the adsorbents obey Langmuir isotherm model, and the empirical adsorption findings were fitted with the second-order model kinetically, also non-linear Elovich model. The maximal monolayer adsorption capacities for PAN, PAN/2.5 GO, and PAN/5 GO were found to be 57.4, 66.18, and 69.7 mg/g, respectively. Thermodynamic studies discovered that the adsorption of phenol on all adsorbents nanofiber mats was exothermic, the adsorption of phenol on nanofiber mats decreases as the temperature increases. All the adsorbents exhibit negative enthalpy and entropy. The PAN/GO composite's superior phenol removal suggested that it could be used as a latent adsorbent for efficient phenol removal from water and wastewater streams.

Efficient Removal of Phenol and Aniline from Aqueous Solutions Using Graphene Oxide/polypyrrole Composites

Recyclable Graphene Oxide Grafted with Poly(n-Isopropylacrylamide) and Its Enhanced Selective Adsorption for Phenols

Extraction-like Removal of Organic Dyes from Polluted Water by the Graphene Oxide/pnipam Composite System

Adsorption of chlorpyrifos in water using polyaniline/graphene oxide composites

Effective Removal of Phosphate from Aqueous by Graphene Oxide Decorated with -Fe_2O_3 : Kinetic, Isotherm, Thermodynamic and Mechanism Study

A novel method for the functionalization of graphene oxide with polyimidazole for highly efficient adsorptive removal of organic dyes

Bio-Inspired Surface-Functionalization Of Graphene Oxide For The Adsorption Of Organic Dyes And Heavy Metal Ions With A Superhigh Capacity

p-Phenylenediamine-modified graphene oxide as a sorbent for solid-phase extraction of phenylurea herbicides, nitroimidazoles, chlorophenols, phenylurea insecticides and phthalates

Hydrothermal Fabrication of Novel Three-Dimensional Graphene Oxide-Pentaerythritol Composites with Abundant Oxygen-Containing Groups As Efficient Adsorbents

Adsorptive Removal of Indomethacin and Diclofenac from Water by Polypyrrole Doped-Go/cof-300 Nanocomposites

Synthesis of Layer‐By‐Layer Decorated Graphene Oxide with Bismuth Telluride Nanoparticles‐modified Dendrimer: Application for Nonylphenol Removal from Aqueous Solutions

Ionic Liquids Modified Graphene Oxide Composites: A High Efficient Adsorbent for Phthalates from Aqueous Solution

Tuning the Surface Functionality of Polyethylene Glycol-Modified Graphene Oxide/chitosan Composite for Efficient Removal of Dye.

Fabrication Of Polypyrrole/Graphene Oxide Composite Nanosheets And Their Applications For Cr(Vi) Removal In Aqueous Solution

Fabrication of Novel Covalently-Coupled Graphene Oxide-Per-6-amino-β-cyclodextrin Composite with Abundant Active Oxygen- and Nitrogen-Containing Sites for Azo Dyes Removal

Magnetic Porous Silica–graphene Oxide Hybrid Composite As a Potential Adsorbent for Aqueous Removal of P-Nitrophenol

A Graphene Oxide-Based Polymer Composite Coating for Highly-Efficient Solid Phase Microextraction of Phenols.

Facile and Highly Efficient Fabrication of Graphene Oxide-Based Polymer Nanocomposites Through Mussel-Inspired Chemistry and Their Environmental Pollutant Removal Application

Removal of Phenols from Aqueous Solutions by Graphene Oxide Nanosheet Suspensions

Hypercrosslinked porous polymers hybridized with graphene oxide for water treatment: dye adsorption and degradation

Thermodynamic and kinetic analysis of the response surface method for phenol removal from aqueous solution using graphene oxide-polyacrylonitrile nanofiber mats