Abstract:Pneumatic submersible pump is a new type of drainage tool in farmland irrigation. The water supply at the pumping end of the submersible pump is sporadic with frequent no-load operation given the low water levels in most rural canals during summer. The change in water flow and pressure directly causes high turbine speed and thus leads to the runaway speed phenomenon, which seriously affects operational safety. A pneumatic control system based on metering-out control was proposed to prevent high turbine speed and minimize the consumption of the pneumatic submersible pump in irrigation and drainage. First, the pneumatic liquid level control system was designed to automatically adjust the pressure and flow of the submersible pump under no-load and load conditions. Second, the stability of the system was simulated by Advanced Modeling and Simulation Environment for Systems Engineering (AMESim), and the coupling relationship among turbine speed, inlet pressure, and flow rate was discussed with different metering-out flows. Finally, comparative experiments were conducted for verification. Simulation and experimental results show that under the no-load condition, when the inlet pressure reaches 0.2 Mpa, the rotating speed of the pneumatic submersible pump increases with the inlet pressure, and when the inlet pressure reaches 0.4 Mpa, the rotating speed of the pneumatic submersible pump remains approximately unchanged. When the outlet flow increases, the rotating speed of the pneumatic submersible pump also increases gradually; when the outlet flow is equal to the inlet flow, the rotating speed remains stable; when the inlet pressure is higher than 0.4 Mpa and the outflow flow is smaller than 18 m/h, the turbine speed can be less than 12000 r/min, which is lower than the critical runaway speed. Thus, the total power loss is not reduced. The control system solves the problem of runaway speed and realizes automatic speed control of the pneumatic submersible pump under the no-load condition. The proposed method provides wide application prospects and is suitable for discontinuous irrigation and drainage operation of rural canals.

Study on the control methods of a water hydraulic variable ballast system for submersible vehicles

Some Practical Improvements of Sliding-Mode Control for Servo-Solenoid Valve.

Research on the Depth Control Strategy of an Underwater Profiler Driven by a Mixture of Ocean Thermal Energy and Electric Energy

New Design of the Control System for Hydro-Viscous Clutch

Advanced Valves and Pump Coordinated Hydraulic Control Design to Simultaneously Achieve High Accuracy and High Efficiency.

Design and Experimental Study on the Automatic Speed Control System of a Pneumatic Submersible Pump

Pump/valves coordinate control of the independent metering system for mobile machinery

Water level control of submarine hovering tank based on sliding mode control

Development of Parallel-Connected Pump–valve-Coordinated Control Unit with Improved Performance and Efficiency

Analysis of Pressure and Flow Compound Control Characteristics of an Independent Metering Hydraulic System Based on a Two-Level Fuzzy Controller

Self-correcting PWM Control for Dynamic Performance Preservation in High Speed On/off Valve

Hierarchical Control of Underwater Vehicle Variable Ballast Systems

Designing an Improved Controller for a Pump Direct Driven Electro-Hydraulic System Using a Nonlinear Flow Mapping

Velocity-tracking Control of the Variable-speed Controlled Hydraulic System: Using Compound Algorithm of PD & Feedforward-feedback Control

Research on Energy-saving Optimization of Parallel Pumping System

RESEARCH ON COMPENSATION FOR VARIABLE DEAD-ZONE CHARACTERISTIC OF ELECTRO-HYDRAULIC PROPORTIONAL DIRECTION VALVE IN POSITION CONTROL

Simulation Of Separate Meter In And Separate Meter Out Control Of Electro Hydraulic Load Sensing System

High-Speed On/Off Control For Remotely Operated Underwater Vehicles Propulsion

A new nethod of improving comprehensive performances of variable speed pump control systems with large power: Vvalve-pump parallel variable structure control

High-gain observer-based pump/valve combined control for heavy vehicle electro-hydraulic servo steering system

Linear Control of Switching Valve in Vehicle Hydraulic Control Unit Based on Sensorless Solenoid Position Estimation