Abstract:The formation mechanism of an EFP(explosively formed projectile) using a double curvature liner under the overpressure effect generated by a regular oblique reflection was investigated in this paper. Based on the detonation wave propagation theory, the change of the incident angle of the detonation wave collision at different positions and the distribution area of the overpressure on the surface of the liner were calculated. Three-dimensional numerical simulations of the formation process of the EFP with tail as well as the ability to penetrate 45# steel were performed using LS-DYNA software, and the EFP velocity, the penetration ability, and the forming were assessed via experiments and x-ray photographs. The experimental results coincides with those of the simulations. Results indicate that the collision of the detonation wave was controlled to be a regular oblique reflection acting on the liner by setting the dimensions of the unit charge and maintaining the pressure at the collision point region at more than 2.4 times the CJ detonation when the incident angle approached the critical angle. The distance from the liner midline to the boundary of the area within which the pressure ratio of the regular oblique reflection pressure to the CJ detonation pressure was greater than 2.5, 2, and 1.5was approximately 0.66 mm, 1.32 mm, and 3.3 mm, respectively. It is noted that pressure gradient caused the liner to turn inside out in the middle to form the head of the EFP and close the two tails of the EFP at approximately 120μs. The penetration depth of the EFP into a 45# steel target exceeded 30mm, and there was radial expansion between the head and tail of the EFP, increasing the penetration resistance of the EFP. Therefore, the structural size of the unit charge and the liner can be further optimized to reduce resistance to increase the penetration ability of the EFP.

Dynamic Behaviors of Multi-Layered Steel Targets with Air Gaps Subjected to the Impact of Efp Simulants

Numerical Study on the Perforation of Steel Plates by Multiple Projectiles

Investigation into Damage Characteristics and Ballistic Performance of In-Contact Multi-Layer Steel Targets Subjected to High-Velocity Impact by Explosively Formed Projectiles

Numerical simulation of the disk fragment impacting resistance of plate target

Impact Performance of Explosively Formed Projectile (EFP) into Concrete Targets

Oblique penetration performance of Explosively Formed Projectile (EFP) on 6061 aluminum target:experiments and simulations

Failure mode and energy absorption mechanism of steel/aluminum composite plates impacted by spherical fragment

Experimental and numerical study on the flight and penetration properties of explosively-formed projectile

Perforation of steel and aluminum targets using a modified Johnson–Cook material model

Dynamic Response of Fully-Clamped Steel Plate under Laboratory-Simulated Sequential Fragment Impact and Blast Loading

Oblique Penetration Characteristics of Multi-Layered Spaced Targets by Steel Projectiles

Finite Element Simulation on Ogive-nosed Projectiles Penetrating Single and Multi-layered Concrete Targets

Numerical Simulation of Triple-Layer Reactive Composite EFP Formation and Penetrating Interval Target

A study on the surface overpressure distribution and formation of a double curvature liner under a two-point initiation

Numerical investigation on dynamic damage behavior of a novel N-shaped perforated armor plate under ballistic impact

Dynamic response of UHMWPE plates under combined shock and fragment loading

Dynamic performance of ultralight corrugated sandwich plate with FML face-sheets impacted by FSP-foam composite projectile

Damage of Multi-Layer Spaced Metallic Target Plates Impacted by Radial Layered PELE

Flight and penetration behaviors of tandem efps with fins

Ballistic performance of ultra-high molecular weight polyethylene laminates against fragment-simulating projectiles

Penetration Trajectory of Concrete Targets by Ogived Steel Projectiles–experiments and Simulations