Epoxidation of Olefins Using a Dichlorodioxomolybdenum(vi)-Pyridylimine Complex As Catalyst

Salete S. Balula,Sofia M. Bruno,Ana C. Gomes,Anabela A. Valente,Martyn Pillinger,Isabel S. Goncalves,Duncan J. Macquarrie,James H. Clark
DOI: https://doi.org/10.1016/j.ica.2012.01.029
IF: 3.118
2012-01-01
Inorganica Chimica Acta
Abstract:The ligand N-(n-propyl)-2-pyridylmethanimine (pyim) and an immobilized analogue of this ligand (pyim-MTS) were prepared by the condensation reaction of 2-pyridinecarboxaldehyde with either n-propylamine or 3-aminopropyl groups covalently attached to a micelle-templated silica (MTS). Free and immobilized dioxomolybdenum(VI) complexes of the type MoO2Cl2(L1) (L1=pyim (1), pyim-MTS) were then prepared by treatment of the organic ligand or ligand-silica with the solvent adduct MoO2Cl2(THF)2. MoO2Cl2(pyim) (1) is a highly active catalyst for the epoxidation of olefins (cyclooctene (Cy), cyclododecene, 1-octene, trans-2-octene, R-(+)-limonene) at 55°C using tert-butylhydroperoxide (TBHP) as the oxidant under solvent-free conditions, giving the corresponding epoxides as the only reaction products. A turnover frequency of 1855molmolMo−1h−1 was measured for the epoxidation of Cy, and the epoxide (CyO) was formed quantitatively within 4.5h. The MTS-supported complex was less active, and exhibited temperature-dependent leaching of active species. As an alternative approach to facilitating catalyst recycling, complex 1 was investigated with the ionic liquid (IL) 1-butyl-3-methylimidazolium tetrafluoroborate as solvent. The 1/IL phase could be reused, giving ca. 95% CyO yield in each run.
What problem does this paper attempt to address?