Abstract:An yttria-stabilized zirconia (YSZ) (111) substrate is a promising candidate for the growth of c-plane InN due to its small lattice mismatch of 2.7%. Polarity control of InN (0001) films on YSZ substrates is a crucial issue for device fabrication because mixture of In-polar and N-polar InN will degrade device performance. We have recently found that thermal annealing of the YSZ (111) substrates leads to the formation of In-polar InN films. This phenomenon is probably caused by segregation of the Y atoms at the surfaces of the YSZ substrates [1]. In this presentation, we will discuss the polarity determination of c-plane InN films grown on YSZ (111) substrates based on the calculated adsorption energies for the In atom on the N-covered YSZ (111) surface. A cubic zirconia (111) slab is employed as the Y-segregation free substrate. For the Y-segregated substrate, all Zr atoms in the upper half of the zirconia in the cell were replaced with Y atoms. Firstly, adsorption energies of the In and N atoms on the YSZ surfaces are calculated. The large adsorption energy for N atoms compared with that for In atoms suggests that the first layer on the Y-segregated YSZ (111) surfaces should consist of N atoms. Calculations of the adsorption energies of an In atom on the N adatoms covering the surfaces was performed to investigate the polarity dependence of the stability of InN on YSZ. As shown in Fig.1, an In atom at the center of three N atoms (‘‘Hollow N’’) leads to In-polar InN, whereas an In atom on the top of a N atom (‘‘Top N’’) results in N-polar InN. According to the calculations shown in table 1, In-polar InN is more stable on the Y-segregated surfaces. On the other hand, the energy difference between the In-polar and N-polar InN on the segregation-free cubic zirconia surfaces is quite small. These data are quite consistent with the experimental results. [1] A. Kobayashi, K. Okubo, J. Ohta, M. Oshima and H. Fujioka, Phys. Status Solidi A 209, 2251 (2012). Substrate Adsorption energy of In

Theoretical Study of the Initial Stage of Inn Growth on Cubic Zirconia (111) Substrates

Theoretical study of InN growth on Mn-stabilized zirconia (111) substrates

Initial Stages of the Cubic-Inn Growth with the Technique of the Pre-Deposition of Indium

Theoretical investigation of polarity determination for c-plane InN grown on yttria-stabilized zirconia (111) substrates

Theoretical Investigation of the Polarity Determination for C-Plane Inn Grown on Yttria-Stabilized Zirconia (111) Substrates with Yttrium Surface Segregation

InN growth on BaTiO3 (111) substrates: A first-principles study

InN doped with Zn: Bulk and surface investigation from first principles

First-principles study of Sr adsorption on InN (0001)

Electronic Structure and Trilayer Growth of Indium Films on Si(111): a Photoemission Study

Study of InN/GaN interfaces using molecular dynamics

Synthesis and Growth of InN with Pre-deposited Indium Nanodots Method on MOCVD at Low Temperature

First stages of the InP(1 0 0) surfaces nitridation studied by AES, EELS and EPES

Characterization of InN Grown Directly on Sapphire Substrate Using Plasma‐Enhanced Metal Organic Chemical Vapor Deposition

Enhancing indium bilayer nitridation through novel hydrogen insertion process in InN epitaxy: A kinetic mechanism

Structural Properties of InN on PbTiO 3 (111) Surfaces

Growth and Characterization of Inn Thin Films on Sapphire by Mocvd

Effects of Indium Surfactant on the Crystalline and Optical Properties of GaN During Initial Growth Stage

InN and GaN/InN monolayers grown on ZnO {0001}

Numerical simulation study on growth rate and gas reaction path of InN-MOCVD with Close-Coupled showerhead reactor

Atomic Structure for Mg on Inn(0001) Surface

Nitridation of InP(1 0 0) surface studied by synchrotron radiation