Abstract:Crescent‐shaped hydrogel microparticles have been shown to template uniform volume aqueous droplets upon simple mixing with aqueous and oil media for various bioassays. This emerging "lab on a particle" technique requires hydrogel particles with tunable material properties and dimensions. The crescent shape of the particles is attained by aqueous two‐phase separation of polymers inside a spherical droplet followed by photopolymerization of the curable precursor. In this work, we have investigated the phase separation of photo‐curable poly(ethylene glycol) diacrylate (PEGDA, Mw 700) and dextran (Mw 40,000) for tunable manufacturing of crescent‐shaped particles. The particles' morphology was precisely tuned by following a phase diagram, varying the UV intensity, and adjusting the flow rate ratio between the three streams, containing PEGDA, dextran, and oil, within a microfluidic droplet generation device. The fabricated particles with variable cavity sizes and outer diameters encapsulated uniform aqueous droplets upon mixing with a continuous oil phase. The particles were fluorescently labeled with red and blue emitting dyes at variable concentrations to produce six color‐coded particles. The blue fluorescent dye showed a moderate response to the pH change from 1 to 7 in terms of an increase in emitted intensity. The fluorescently labeled particles were able to tolerate an extremely acidic solution (pH 1) but disintegrated within an extremely basic solution (pH 14). The particle‐templated droplets were able to effectively retain the disintegrating particle and the fluorescent signal at pH 14, indicating completely segregated compartments. This article is protected by copyright. All rights reserved

Microdroplet Patterning: Designer Hydrophilic Regions Regulate Droplet Shape for Controlled Surface Patterning and 3D Microgel Synthesis (small 3/2012)

Designer Hydrophilic Regions Regulate Droplet Shape For Controlled Surface Patterning And 3d Microgel Synthesis

Wetting Behaviors and Mechanism of Micro Droplets on Hydrophilic Micropillar-Structured Surfaces

Surface-Controlled Shape Design of Discotic Micro-Particles

Controlled Stretching and Splitting Behaviors of Nanodroplets by Designing Surface Wettability Patterns

Designing Laplace Pressure Pattern for micro-Droplet Manipulation.

The Influence of Gradient Patterned Design on Nanoshapes Deposition

Droplet shape control using microfluidics and designer biosurfactants

Precisely writing/printing hydrogel patterns on polymer surfaces

Fabricating patterned microstructures by embedded droplet printing on immiscible deformable surfaces

Patterned Slippery Surface Through Dynamically Controlling Surface Structures for Droplet Microarray

Polygonal non-wetting droplets on microtextured surfaces

Liquid Nanodroplets Spreading on Chemically Patterned Surfaces

Fluid Flower : Microliquid Patterning via Drop Impact

Printing Patterned Fine 3d Structures By Manipulating The Three Phase Contact Line

Fabrication of Crescent Shaped Microparticles for Particle Templated Droplet Formation

A Superhydrophobic Surface Patterned with Hydrophilic Channels for Directional Sliding Control and Manipulation of Droplets

Controllable Water Adhesion and Anisotropic Sliding on Patterned Superhydrophobic Surface for Droplet Manipulation

Guided organization of λ-DNA into microring arrays from liquid capillary bridges.

Breath-Taking Patterns: Discontinuous Hydrophilic Regions for Photonic Crystal Beads Assembly and Patterns Revisualization

Patterned Arrays of Supramolecular Microcapsules