Abstract:This paper investigates a failure of a 35 kV neutral point unearthed system in a hilly territory at the altitude about 1 000 m.The system's No.1 busbar electromagnetic voltage transformer(PT)had exploded with an open-circuit bus connected.Then the PT was replaced and a harmonic eliminating device was installed. However,the PT exploded again soon after the replacement.High voltage diagnostic tests and oil tests were conducted,and the changes of electric properties and insulation strength after the failure were obtained by comparing with historical data.Waveform recorded during the failure was also analyzed.Discharge to earth was found at the common terminal of the PT's primary side,and apparent changes in the phase difference of the three-phase voltage were observed in the waveform.The cause of the failure is summarized to be improper insulation match between the PT and the harmonic eliminating device.As a result of the poor match,single-phase arc grounding occurred to cause over-voltage on the N-terminal and subsequent breakdown of its insulation to earth,which resulted in malfunction of the harmonic eliminating device,and subsequently resulted in rare fundamental frequency parallel resonance of single-phase(phase A) and 1/2 fundamental frequency resonance of phase B.The induced heavy current blew the primary side fuse to make the PT overheat and then explode. The investigation result suggests that this kind of failure can be avoided by proper selection of the device type.

PSCAD Simulation Study on the Distribution Network Voltage Transformer Failure

The simulation platform of 10kV distribution network based on PSCAD/EMTDC

Simulation analysis and improved measures for preventing potential transformer fault in 10 kV distribution networks

Intermittent Arc Grounding Accident Simulation Analysis and Solution Research in One Practical Distribution System

Influence of load-side transformers and grounding impedance on short-circuit fault simulation

Analysis of Fault Characteristics of Distribution Network with PST Loop Closing Device under Small Current Grounding System

An Active Voltage-Type Grounding Fault Protection Method for Medium-Voltage Distribution Networks with Neutral Point Voltage Flexible Regulation

Study on fault waveform library of PT high voltage side fuse in hydropower station

The Research on the Impact Characteristic of the Grounding Device of 10 kV Distribution Line Based on PSCAD

Analysis of Successive Explosions of a 35 Kv Electromagnetic Potential Transformer

Single‐phase Grouding Fault Analysis and Control Scheme of Transformerless Flexible Multistate Switch

Numerical and Experimental Simulation Researches on Characteristics of Ferroresonance Based on Distributed Power Grid Parameters

Study on simulation of ferroresonance elimination in 10kV power system

Fault Analysis And Simulation Of Ground-Fault Accident On Transformer In 500 Kv Ac/Dc Grids

Identification and Simulation of Single-Phase Grounding Fault in Neutral Point Insulation System

Fault Transient Simulation Of Middle-Voltage Flexible Dc Distribution System

Analysis of Effect of Short Circuit Fault on 220 kV Partial Grounding Transformer

The Electromagnetic Transient Modeling and Simulation of 10 Kv/400 V EPT

Phase Current Based Fault Section Location for Single-Phase Grounding Fault in Non-effectively Grounded Distribution Network

Experimental Research on Typical Single-Phase High Resistance Grounding Fault Detection Methods in Resonant Grounding Distribution System

Application of the Simulation Platform for Teaching in the Electrical Engineering