Abstract:It is a great challenge to improve the process stability in conventional underwater wet welding due to the formation of unstable bubble. In this study, mechanical constraint method was employed to interfere the bubble generated by underwater wet welding, and the new method was named as mechanical constraint assisted underwater wet welding. The aim of the study was to quantify the combined effect of wire feed speed and condition of mechanical constraint on the process stability in mechanical constraint assisted underwater wet welding. Experimental results demonstrated that the introduction of mechanical constraint not only suppressed the bubble without floating but also stabilized the arc burning process. The degree of influence of mechanical constraint, which changed with wire feed speed, played an important role during the mechanical constraint assisted underwater wet welding process. For all wire feed speeds, the fluctuations of welding electrical signal were decreased through introduction of mechanical constraint. The difference in the proportion of arc extinction process between underwater wet welding and mechanical constraint assisted underwater wet welding became less with increasing wire feed speed. At wire feed speed lower than 7.5 m/min, the improvement of process stability was very significant by mechanical constraint. However, the further improvement produced limited effect when the wire feed speed was greater than 7.5 m/min. The observation results showed that a better weld appearance was afforded at a large wire feed speed, corresponding to a lower variation coefficient.

A Study on the Arc Characteristics of Underwater Wet Welding Process

Analysis of Underwater Wet Welding Seam Forming Based on Arc Sensor Information

Characterization of the underwater welding arc bubble through a visual sensing method

Modeling Of Underwater Wet Welding Process Based On Visual And Arc Sensor

Arc Stability Indexes Evaluation of Ultrasonic Wave-Assisted Underwater FCAW Using Electrical Signal Analysis

Modeling and Analysis of Underwater Wet Weld Process Based on Regression Method

Research on the Characteristics of Manual Arc Welding Equipment Underwater Wet Welding

Effect of Boric Acid Concentration on the Arc Stability in Underwater Wet Welding

Control weld geometric parameters when wet underwater welding

Correlation between wire feed speed and external mechanical constraint for enhanced process stability in underwater wet flux-cored arc welding

Investigation on Dynamic Behaviors of Bubble Evolution in Underwater Wet Flux-Cored Arc Welding

Effects of processing parameters on arc stability and cutting quality in underwater wet flux-cored arc cutting at shallow water

Experimental Study of Arc Bubble Growth and Detachment from Underwater Wet FCAW

Investigation of Process Stability and Weld Quality of Underwater Wet Flux-Cored Arc Welding of Low-Alloy High-Strength Steel with Oxy-Rutile Wire

Finite element analysis of the angular distortion and residual stress in underwater wet welding

A Study on Modeling of CO2 Weld Seam Forming Quality

Design and Numerical Simulation on Local Dry Welding Rotating Arc Sensor

Study of underwater wet welding stability using an X-ray transmission method

Effect of Parameters Change on the Weld Appearance in Stainless Steel Underwater Wet Welding with Flux-Cored Wire

Investigation of Arc Bubble Affecting the Arc Stability and Improvement of Weld Appearances Using Bubble Constraint Device in Underwater Wet Welding

A Survey of Underwater Wet Weld Seam Tracking Based on Ultrasonic Sensor