Abstract:The utilization of numerical analytic techniques has become essential in evaluating the environmental consequences of excavation in foundation pits. The careful selection of suitable soil constitutive models has significant importance in this regard. The Hardening Soil (HS) model has become widely utilized in the numerical analysis of foundation pits among the several models considered. The essence of a constitutive model is in the identification and determination of its calculation parameters. The stress–strain curve is derived by conducting triaxial testing, utilizing the inherent properties of the particle swarm optimization (PSO) technique. The objective function entails quantifying the disparity between stress–strain curves obtained from various parameters and experimental curves while iteratively searching for five crucial parameters of soil‐hardening models: effective internal friction angle φ, effective cohesion, failure ratio R f , stiffness level‐dependent power exponent, and standard triaxial‐drained test secant stiffness . The objective of this research is to create a computational software utilizing the Python programming language to execute PSO with the purpose of determining sets of five fundamental soil constitutive parameters. This research employs optimized parameters acquired from PSO to construct a numerical model for foundation pits and performs numerical computations. Accurate findings may be reached by comparing the measured deformation in the numerical simulation with that seen in actual foundation pits. The results demonstrate a high degree of consistency between the experimental curves and the five parameter combinations obtained through the PSO algorithm, with an error rate not exceeding 8.2%. Moreover, the optimized curves exhibit closer alignment with theoretical expectations. The settlement values calculated using a numerical model based on optimized parameters show only a 6.12% deviation from actual measurements while closely following the trend of the observed curve. This outcome has the potential to greatly alleviate the burden of conducting indoor tests and holds considerable practical value in engineering applications. The observable optimization impact of PSO also serves as evidence of its viability in improving soil constitutive parameters, providing new perspectives and sources of information for future progress in this domain.

Investigation into MOGA for Identifying Parameters of a Critical-State-based Sand Model and Parameters Correlation by Factor Analysis

Selection of Sand Models and Identification of Parameters Using an Enhanced Genetic Algorithm

A Combined Machine Learning/search Algorithm-Based Method for the Identification of Constitutive Parameters from Laboratory Tests and In-Situ Tests

Multiple Parameters Determination Method of Hardening Soil Model Based on Particle Swarm Optimization

Inverse Procedure for Determining Model Parameter of Soils Using Real-Coded Genetic Algorithm

Optimization techniques for identifying soil parameters in geotechnical engineering: Comparative study and enhancement

A State-Dependent Constitutive Model for Coarse-Grained Gassy Soil and Its Application in Slope Instability Modelling

Micromechanics-based multimechanism bounding surface model for sands

An efficient optimization method for identifying parameters of soft structured clay by an enhanced genetic algorithm and elastic–viscoplastic model

Experimental Study on the Correlation Between Shear Characteristic and Physical Parameters of Paddy Soil in Plastic State

Modelling the Evolving Critical State of Crushable Soils and Parameter Optimization with an Improved Genetic Algorithm (AIS-RCGA)

Metaheuristic model for the interface shear strength between granular soil and structure considering surface morphology

Multi-objective analysis of the Sand Hypoplasticity model calibration

Parameter identification of nonlinear constitutive model for conditioned soils by using genetic algorithm

Identifying parameters of advanced soil models using an enhanced transitional Markov chain Monte Carlo method

A methodology for parameter identification and calibration of the cohesive element based meso-scale concrete model

Identifying Soil Parameters From Excavation Using Moop

Parameter Estimation for Coupled Hydromechanical Simulation of Dynamic Compaction Based on Pareto Multiobjective Optimization

Study On Parameters Sensibility Analysis Model Of Landslide Stability Considering Correlation

Study on the correlation and calibration of macro and micro parameters of discrete element model for sandstone