Abstract:This work aims to elucidate the hot deformation behavior and microstructure evolution of a non-equimolar TiZrHf-rich refractory high-entropy alloy (RHEA) with a composition of Ti2ZrHfV0.5Ta0.2 (at. %). The as-cast Ti2ZrHfV0.5Ta0.2 alloy composed solely of a body-centered cubic phase showed superior tensile mechanical properties with a yield strength of 865 MPa and a total elongation of 22.5%. The uniaxial compression tests were performed at temperatures ranging from 900 to 1100 °C and strain rates varying from 10−3 to 10−1 s−1. The relation among the flow stress, deformation temperature, and strain rate was represented by the Arrhenius-type constitutive equations. The calculations show a comparatively low apparent activation energy of 144–119 kJ/mol over the entire range of strains, revealing a noticeable contradiction between the concentration of group IV elements (Ti, Zr, Hf) and the high-temperature strength. The excessive addition of Group IV elements tends to deteriorate the high-temperature strength due to the relatively low melting points and self-diffusion activation energies of Group IV elements. The misorientation analysis based on electron back-scattered diffraction indicated that the dynamic recrystallization mechanism depends strongly on the thermo-mechanical processing conditions. A low deformation temperature and high strain rate results in an abnormal discontinuous dynamic recrystallization mechanism. Additionally, the dominant role played by the edge dislocation in RHEAs during deformation is supposed to be the reason for the abnormal discontinuous dynamic recrystallization mechanism. A series of stress drops were observed under low deformation temperatures and high strain rates. Based on an interrupted hot-compression experiment and a strain aging experiment, the stress drop can be attributed to the unlocking of dislocations pinned by the Cottrell atmosphere or short-range ordering.

Erratum To: Temperature Effects on Deformation and Serration Behavior of High-Entropy Alloys (Heas)

Experiments and Model for Serration Statistics in Low-Entropy, Medium-Entropy and High-Entropy Alloys

High-entropy alloys: a review of mechanical properties and deformation mechanisms at cryogenic temperatures

Temperature effect on tensile behavior of an interstitial high entropy alloy: Crystal plasticity modeling

On temperature and strain-rate dependence of flow serration in HfNbTaTiZr high-entropy alloy

Strain rate dependent deformation behavior of BCC-structured Ti29Zr24Nb23Hf24 high entropy alloy at elevated temperatures

Temperature-dependent mechanical behavior of an Al 0.5 Cr 0.9 FeNi 2.5 V 0.2 high-entropy alloy

Atomistic Simulations of Ductile Failure in a b.c.c. High-Entropy Alloy

Serrated flow stress and nano-precipitation in (CoCrFeNi)94Ti2Al4 high entropy alloy

In-situ study of room temperature tensile deformation of a CrMnFeCoNi high-entropy alloy

Hot deformation behavior and microstructure evolution of non-equimolar Ti2ZrHfV0.5Ta0.2 refractory high-entropy alloy

Effect of Temperature on the Mechanical Abnormity of the Quasicrystal Reinforced Mg–4%Li–6%Zn–1.2%Y Alloy

Ductile and brittle crack-tip response in equimolar refractory high-entropy alloys

Peierls barrier characteristic and anomalous strain hardening provoked by dynamic-strain-aging strengthening in a body-centered-cubic high-entropy alloy

Cooperative deformation in high-entropy alloys at ultralow temperatures

Abnormal hardening and amorphization in an FCC high entropy alloy under extreme uniaxial tension

Mechanical behavior of high-entropy alloys: A review

Temperature-dependent dynamic compressive properties and failure mechanisms of the additively manufactured CoCrFeMnNi high entropy alloy

Anomalous size effect on yield strength enabled by compositional heterogeneity in high-entropy alloy nanoparticles

Temperature-dependent yield stress of single crystals of non-equiatomic Cr-Mn-Fe-Co-Ni high-entropy alloys in the temperature range 10-1173 K

Elastic strain-induced amorphization in high-entropy alloys