Abstract:Ice-breaking methods have become increasingly significant with the ongoing development of the polar regions. Among many ice-breaking methods, ice-breaking that utilizes a moving load is unique compared with the common collision or impact methods. A moving load can generate flexural-gravity waves (FGWs), under the influence of which the ice sheet undergoes deformation and may even experience structural damage. Moving loads can be divided into above-ice loads and underwater loads. For the above-ice loads, we discuss the characteristics of the FGWs generated by a moving load acting on a complete ice sheet, an ice sheet with a crack, and an ice sheet with a lead of open water. For underwater loads, we discuss the influence on the ice-breaking characteristics of FGWs of the mode of motion, the geometrical features, and the trajectory of motion of the load. In addition to discussing the status of current research and the technical challenges of ice-breaking by moving loads, this paper also looks ahead to future research prospects and presents some preliminary ideas for consideration.
What problem does this paper attempt to address?
### Problems the paper attempts to solve
This paper mainly explores how to use the method of moving loads to break ice in the context of the increasing demand for resource development in polar regions and passage through the Arctic shipping lanes. Traditional ice - breaking methods usually use icebreakers for collision or impact, but in extremely thick ice conditions, ships may get trapped. Therefore, researchers are constantly exploring new ice - breaking methods to improve ice - breaking capabilities. Among them, using moving loads to break ice has the advantages of high efficiency and cleanliness.
Specifically, the paper attempts to solve the following key problems:
1. **Mechanisms of ice deformation and fracture caused by moving loads**:
- Moving loads can generate Flexural - Gravity Waves (FGWs) on the ice surface, and these waves will cause ice surface deformation and even structural damage. The paper discusses in detail the mechanisms of ice surface deformation and fracture under different conditions, including intact ice surfaces, ice surfaces with cracks, and ice surfaces with open waterways.
2. **The influence of different types of moving loads on ice - breaking effects**:
- Moving loads can be divided into loads on the ice surface and underwater loads. For loads on the ice surface, the paper discusses the characteristics of FGWs generated when high - speed hovercrafts, aircrafts, and vehicles move on the ice surface. For underwater loads, the paper discusses the influence of the motion patterns, geometric features, and motion trajectories of the loads on ice - breaking characteristics.
3. **Current research status and technical challenges**:
- The paper reviews the current research progress on using moving loads to break ice and points out the existing technical challenges. For example, how to evaluate the bearing capacity of the ice surface and how to optimize the ice - breaking effect of moving loads under different ice surface conditions.
4. **Future research prospects**:
- The paper looks forward to future research directions and proposes some preliminary ideas, such as improving numerical simulation methods and developing new experimental techniques, to further promote research in this field.
### Key formulas
- **Propagation speed of flexural - gravity waves**:
- When the wavelength is long, gravity dominates, and the phase velocity \( c_p \) of the wave is greater than the energy propagation velocity \( c_g \) of the wave.
- When the wavelength is short, elastic force dominates, and \( c_p \) is less than \( c_g \).
- There is a critical wavelength such that \( c_p = c_g \), which is called the first critical velocity \( c_{cr,1} \).
\[
c_{cr,1}=\sqrt{\frac{gH}{\pi}}
\]
- **Second critical velocity**:
- The second critical velocity \( c_{cr,2} \) is defined as \( c_{cr,2}=\sqrt{gH} \), where \( g \) is the gravitational acceleration and \( H \) is the water depth.
- When the load moves at the speed of \( c_{cr,2} \), the proportion of ice surface deformation increasing with time \( t \) is \( t^{1/3} \).
\[
c_{cr,2}=\sqrt{gH}
\]
### Summary
The paper systematically explores the method of using moving loads to break ice through comprehensive analysis of theoretical research, experimental results, and numerical simulation. The research not only has important academic value but also has broad application prospects, especially in polar resource development and the navigation of the Arctic shipping lanes.