Abstract:We propose a sharp interface model for simulating solid-state dewetting where the surface energy is (weakly) anisotropic. The morphology evolution of thin films is governed by surface diffusion and contact line migration. The mathematical model is based on an energy variational approach. Anisotropic surface energies lead to multiple solutions of the contact angle equation at contact points. Introduction of a finite contact point mobility is both physically based and leads to robust, unambiguous determination of the contact angles. We implement the mathematical model in an explicit finite difference scheme with cubic spline interpolation for evolving marker points. Following validation of the mathematical and numerical approaches, we simulate the evolution of thin film islands, semi-infinite films, and films with holes as a function of film dimensions, Young's angle $\theta_i$, anisotropy strength and crystal symmetry, and film crystal orientation relative to the substrate normal. We find that the contact point retraction rate can be well described by a power-law, $l \sim t^n$. Our results demonstrate that the exponent $n$ is not universal -- it is sensitive to the Young's angle $\theta_i$ (and insensitive to anisotropy). In addition to classical wetting (where holes in a film heal) and dewetting (where holes in a film grow), we observe cases where a hole through the film heals but leave a finite size hole/bubble between the continuous film and substrate or where the hole heals leaving a continuous film that is not bonded to the substrate. Surface energy anisotropy (i) increases the instability that leads to island break-up into multiple islands, (ii) enhances hole healing, and (iii) leads to finite island size even under some conditions where the Young's angle $\theta_i$ suggests that the film wets the substrate.

Solid-state dewetting and island morphologies in strongly anisotropic materials

Sharp interface model for solid-state dewetting problems with weakly anisotropic surface energies

Spatially Configuring Wrinkle Pattern and Multiscale Surface Evolution with Structural Confinement

Sharp-Interface Model for Simulating Solid-State Dewetting in Three Dimensions

Convex Splitting Method for Strongly Anisotropic Solid-State Dewetting Problems in Two Dimensions

Structure-preserving parametric finite element methods for simulating axisymmetric solid-state dewetting problems with anisotropic surface energies

Energy-stable parametric finite element approximations for regularized solid-state dewetting in strongly anisotropic materials

Application of Onsager's variational principle to the dynamics of a solid toroidal island on a substrate

A -L Approach for the Simulation of Solid-State Dewetting Problems with Strongly Anisotropic Surface Energies

An Energy-Stable Parametric Finite Element Method for Simulating Solid-state Dewetting Problems in Three Dimensions

A structure-preserving parametric finite element method for solid-state dewetting on curved substrates

Emergence and Growth Dynamics of Wetting-induced Phase Separation on Soft Solids

Modeling solid-state dewetting of a single-crystal binary alloy thin films

A parametric finite element method for solid-state dewetting problems in three dimensions

Dynamics of Small Solid Particles on Substrates of Arbitrary Topography

Analytic Formulations for One-Dimensional Decay of Rectangular Homoepitaxial Islands During Coarsening on Anisotropic Fcc (110) Surfaces

An Extended Morphological Stability Model for a Planar Interface Incorporating the Effect of Nonlinear Liquidus and Solidus

Effects of Surface Tension Anisotropy on Interfacial Instability in Directional Solidification

Modeling metallic island coalescence stress via adhesive contact between surfaces

Dynamics of the Nematic-Isotropic Sharp Interface for the Liquid Crystal.

Modeling the Evolution of Interface Morphologies in Metallic Layered Composites