Stability, aggregation, and sedimentation behaviors of typical nano metal oxide particles in aqueous environment
Hongliang Dai,Ting Han,Junting Cui,Xiang Li,Haq Nawaz Abbasi,Xingang Wang,Zechong Guo,Yong Chen
DOI: https://doi.org/10.1016/j.jenvman.2022.115217
IF: 8.7
2022-08-15
Journal of Environmental Management
Abstract:The wide use of nano metal oxide particles (NMOPs) brings about their inevitable release into the water environment, affecting the environment and human health. Therefore, the stability, aggregation, and sedimentation process of four typical NMOPs (ZnO NPs, CeO2 NPs, TiO2 NPs, and CuO NPs) were investigated in artificial water and real municipal sewage to reveal their complicated behavior. Results showed that NMOPs aggregated at the pH of zero-charge point, and their hydrodynamic diameters and aggregation rates could reach the maximum values. The hydrodynamic diameters and aggregation rates of ZnO NPs, CeO2 NPs, TiO2 NPs, and CuO NPs at the zero-charge point were 617, 1760, 870, 1502 nm, and 31.7, 1158.1, 48.3, 115.7 nm/min, respectively. In addition, the dissolution of NMOPs led to the sedimentation rates under acidic conditions being much lower than those under neutral and alkaline conditions. The aggregation and sedimentation performance of NMOPs were affected by not only pH but also ionic strength (IS) and species. The aggregation rates of NMOPs increased with the increase of IS (0–10 mM), and the maximum aggregation rate of CeO2 NPs was 470.1 nm/min (pH = 7 and CaCl2 = 10 mM). According to Coulomb's law, divalent cations (Mg2+, Ca2+) were more competitively adsorbed on the surface of NMOPs than monovalent cations (K+, Na+), which increased the zeta potential and aggregation rate of NMOPs. Furthermore, the NMOPs were easier to aggregate in municipal sewage because of the homogeneous aggregation between nanoparticles and heterogeneous aggregation with natural colloids. The total interaction energy between NMOPs was calculated by the classical Derjaguin-Landau-Verwey-Overbeek (DLVO) theoretical formula, which was consistent with the experimental results.
environmental sciences