Abstract:Under different ambient temperatures, the thermal aberration certainly affects the imaging quality of infrared multi-spectral camera. Therefore, an athermalized model of infrared multi-spectral cameras is established, and in this model the ambient infrared multispectral camera is equivalent to a separated dual-lens optical system. In the case of the fixed focal length, the influence of the back focal length on the change of the focal power of the front lens and back lens is analyzed. Now, the variation range of the front and rear lens interval is assumed to be restricted. When the back focal length is smaller than the focal length, the ratio of the absolute value of the focal power of the front lens to the absolute value of the focal power of the back lens decreases with the back focal length increasing. The material of the front lens and the back lens have a longer interval on the thermogram. When the back focal length is greater than the focal length, the scenario becomes exactly opposite. Combined with the judgment method of the positive value and negative value of the focal power on the thermogram, the selection range of materials is constrained by the positive value, negative value, and absolute value of focal power, thus realizing the rapid selection of the optical materials. This method is used to design an athermalized infrared multispectral camera with a waveband of 8–14 μm, a focal length of 50 mm, and an F number of 1.4 in a range from –40 ℃ to +60 ℃. Through the simulation analysis, the value of the athermalized infrared multispectral camera, at the Nyquist frequency of 30 lp/mm reaches 0.39, which is close to the diffraction limit; the root mean square radius of the diffuse spot is smaller than the Airy spot radius of 19.17 μm; the axial aberration is less than 0.02 mm, and the design results show that this method can make the long back-focus infrared optical system maintain stable imaging quality in a large temperature range. The SF6 gas is detected experimentally, and the experimental results demonstrate the excellent optical performance of the system.

[Thermal Effect on Optical Properties of Spatial Heterodyne Spectroscopy].

Influence of temperature on infrared optical system and athermal design

Design of Athermalization for Dual-Band Infrared Optical System Based on Harmanic Diffraction

Athermalization Analysis of Infrared Hybrid Refractive-Diffractive Optical Systems

Design of Infrared Hybrid Athermal Optical System

Application of Athermalisation in Optical Systems

Athermal design of long-wave infrared optical system with hybrid refractive/diffractive

Passive Athermalisation in Infrared Optical Systems

Temperature-fluctuation-sensitive accumulative effect of the phase measurement errors in low-coherence interferometry in characterizing arrayed waveguide gratings

Thermal Drift of Optics in Separated-Beam Heterodyne Interferometers

Parameter Rebuilding and Image Quality Evaluation of Optical System at Gradient Temperature

Optical Design of Imaging System Based on Spatial Heterodyne Spectrometer

Correcting Thermal-Emission-induced Detector Saturation in Infrared Spectroscopy

Temperature Nonuniformity Occurring During the Cooling Process of A Kdp Crystal and Its Effects on Second-Harmonic Generation

Design of Spectrophotometer for Measuring Polarized Transmittance and Reflectance at Different Temperature

A Detailed Thermal Analysis of the Binospec Spectrograph

Light Transmission in Thermal Stress-Induced Birefringent Medium

Thermal optical aberrations correction via postprocessing in a raw domain

Study on the Spectral Characteristics of the Narrow-Band Filter in SHS

Analysis of Influence of Long Back Focal Length on Athermal Design Based on Infrared Multispectral Camera

Analysis of the impact of temperature on the spectral shift in ultraviolet hyperspectral imaging spectrometers