Abstract:Measurement of additive residues in food contact materials is important for safety monitoring at the initial stage. Most of the current studies focus on the determination of the migration amounts of chemical hazards from food contact materials into food simulants. Studies on chemical hazard residues in food contact materials are limited to monomers, oligomers, heavy metals, phthalic acid esters, and biphenols, which are known environmental pollutants. Only a few studies have investigated analysis methods for additive residues in food contact materials. In this study, the main factors (monitoring wavelength, chromatographic column, mobile phase, extraction solvent, etc.) that affect the accuracy and sensitivity of eight compounds, including three antioxidants, three light stabilizers, and two plasticizers, were investigated during sample preparation and instrument analysis. A method based on ultrahigh-performance liquid chromatography (UPLC) was developed for the simultaneous determination of these eight additives in polyethylene (PE). The PE food contact material sample was ground to homogenize the particle sizes under freeze-grinding. After comparing the extraction efficiencies of methylbenzene, chloroform, acetone, and acetonitrile, 2.0 g of the sample was extracted with methylbenzene at 80 ℃ and 10.34-11.72 MPa (1500-1700 psi) by accelerated solvent extraction (ASE) for 10 min once. The exaction solvent (10 mL) was transferred and concentrated to near dryness under a gentle stream of nitrogen gas and then re-dissolved in 10 mL of the initial mobile phase (70% (v/v) methanol in water). Finally, the eight compounds were analyzed by UPLC. After optimization of the analytical column and mobile phases, the eight analytes were separated on an ACQUITY UPLC BEH C8 chromatographic column (100 mm×2.1 mm, 1.7 μm) by gradient elution using water and acetonitrile as the mobile phases. The column oven temperature, flow rate of the mobile phase, and injection volume were 30 ℃, 0.3 mL/min, and 5 μL, respectively. The analytes were detected by a diode assay detector (DAD) in the scanning range of 210 nm to 400 nm. The monitoring wavelength was set at 230 nm, 250 nm, 280 nm, and 330 nm. External standard calibration curves were used for quantification. Under the optimized conditions, the calibration curves for the eight compounds showed good linearity in the range of 0.2 μg/mL to 10 μg/mL, and the correlation coefficients were >0.999. The recoveries in spiked blank polyethylene samples at the level of 0.05% were in the range of 83.8% to 103.4%, with relative standard deviations (RSDs) ranging from 0.14% to 7.86%. To validate the method, PE reference materials containing these eight compounds were manufactured at the content level of 0.2% to 0.9%. The recoveries using the prepared reference materials ranged from 63.5% to 118.5%, and the RSDs were in the range of 4.61% to 15.6%. The limits of detection (LODs, S/N=3) of all the eight compounds were 0.005% and the limits of quantification (LOQs, S/N=10) were 0.02%, in compliance with the current legislation. To assess the feasibility and potential of the proposed approach for routine analyses of these eight compounds, the developed method was applied to the analysis of these compounds in ten PE food packages and PE gloves. In six samples, tris(2,4-di-tert-butylphenyl)phosphite (Irganox 168) was detected at a level of 0.02%-0.07%, which was lower than the maximum level of this compound in PE food contact material products regulated in GB 9685-2016 at 0.2%. The method is compliant with the current legislation, and it can be used for the monitoring and supervision of these eight additives in PE food contact materials.

Simultaneous Determination of Eight Additives in Polymer Food Packaging Materials by Ultra-Performance Liquid Chromatography-Electrospray Ionization Tandem Mass Spectrometry

[Simultaneous determination of eight additives in polyethylene food contact materials by ultrahigh-performance liquid chromatography]

METHOD FOR DETERMINATION OF PHTHALATE ESTERS IN FOOD PLASTIC PACKAGING MATERIALS BY GC/MS

Simultaneous Determination of Phthalates and Parabens in Cosmetic Products by Gas Chromatography/Mass Spectrometry Coupled with Solid Phase Extraction

Simultaneous Determination of Multi-Component Mycotoxin Contaminants in Foods and Feeds by Ultra-Performance Liquid Chromatography Tandem Mass Spectrometry.

Simultaneous Determination of Four Water-Soluble Vitamins in Fortified Infant Foods by Ultra-Performance Liquid Chromatography Coupled with Triple Quadrupole Mass Spectrometry.

Analysis of multi-pesticide residues in the foods of animal origin by GC–MS coupled with accelerated solvent extraction and gel permeation chromatography cleanup

Solid Phase Extraction-Ultra High Performance Liquid Chromatography-Tradem Mass Spectrometry for Simultaneous Determination of 13 Restricted Food Additives in Beverages

[Simultaneous Determination of 18 Pharmaceuticals and Personal Care Products in Surface Water by Ultra-High Performance Liquid Chromatography-Tandem Mass Spectrometry].

Identification and Quantification of Unknown Antioxidants in Plastic Materials by Ultrasonic Extraction and Ultra-Performance Liquid Chromatography Coupled with Quadrupole Time-of-Flight Mass Spectrometry

Simultaneous Determination of Nine Photoinitiators in Food Packaging Materials by GC-MS

Development and Validation of Eight Cyanogenic Glucosides Via Ultra-High-performance Liquid Chromatography-Tandem Mass Spectrometry in Agri-Food.

Determination of 8 Organic Pollutants in Drinking Waters by Ultra-high Performance Liquid Chromatography Tandem Mass Spectrometry with Direct Injection

Multi-Residue Analysis of Chemical Additives in Edible Vegetable Oils Using QuEChERS Extraction Method Followed by Supercritical Fluid Chromatography

Simultaneous Determination of Eight Phthalate Ester Plasticizers in Sports Beverages Using Supercritical Fluid Chromatography

Fast Determination of Eleven Food Additives in River Water Using C18 Functionalized Magnetic Organic Polymer Nanocomposite Followed by High-Performance Liquid Chromatography

Simultaneous Determination of 11 Food Additives by Micellar Electrokinetic Capillary Chromatography

Simultaneous determination of eight adulterants in weight management supplements and herbs by HPLC–DAD and LC–MS/MS

Simultaneous determination of triazole fungicides in animal-origin food by ultra-high-performance liquid chromatography coupled with tandem mass spectrometry

Simultaneous determination of 13 pharmaceuticals and personal care products in water using UPLC-MS/MS

Development and validation of a screening and quantification method for simultaneous determination of seven fluorescent whitening agents in commercial flour using UPLC-MS/MS