Abstract:β-carotene is the major carotenoid in carrots and the most widely studied natural carotenoid. It is very import in foods, for it adds the color to the food products, and also associates with human health. For example, it is the most potent precursor of vitamin A and has a potent antioxidant capacity. It also can lower the risk of heart diseases and certain types of cancers. However, the utilization ofβ-carotene as a nutraceutical ingredient in the food industry is currently limited because of its poor water-solubility, high melting point, low chemical stability and bioavailability. Oil-in-water emulsions are often a better choice for deliveringβ-carotene into functional foods since the emulsions increase bioavailability. One factor which can influenceβ-carotene stability in oil-in-water emulsions is the chemical and physical properties of the interface formed between oil and water, as some researchers reported protein has a positive effect on the degradation ofβ-carotene in oil-in-water emulsion. In this research, we usedα-lactalbumin (α-LA) as emulsifier to stabilize nanoemulsion to deliverβ-carotene. The effects ofα-LA on the particle size, the zeta-potential, the encapsulation rate, the oil-water interfacialα-LA concentration, and the physical and chemical stability ofβ-carotene emulsion were determined. The mean particle diameter (Z-average) and zeta-potential ofβ-carotene emulsion were measured using the laser particle size analyzer (Malvern Instruments Ltd.) based on the dynamic light scattering principle. The particle size decreased and the zeta-potential increased with the increasing of the added amount ofα-LA inβ-carotene emulsion; but they did not change significantly (P>0.05) after adding more than 1.50%α-LA as the emulsifier. Adding moreα-LA (0.25%-1.50%), the encapsulation rate was improved in a dose-dependent manner (P<0.05), however, there was no significant difference in the encapsulation rate when more than 1.50%α-LA was added inβ-carotene emulsion. We used Turbiscan Lab Expert to evaluate the physical stability ofβ-carotene emulsion. Turbiscan stability index (TSI) of the top part ofβ-carotene emulsion was determined. TSI decreased with the increasing of the amount of addedα-LA. When the addition ofα-LA was more than 1.50%, there was no change in TSI, which meant the physical stability ofβ-carotene emulsion had become good. To remove continuous phaseα-LA inβ-carotene emulsion, we used the ultra high speed centrifuge to separate the oil phase and aqueous phase. The interfacialα-LA concentration increased significantly with the increasing addition ofα-LA (P<0.05). There was multilayeredα-LA on the interface between oil and water. This could explain the change of particle size, zeta-potential, encapsulation rate and TSI ofβ-carotene emulsion with the increasing addition ofα-LA.β-carotene concentrations in emulsion samples were analyzed through the whole storage time. With lessα-LA (0.25%-0.75%) the more degradation ofβ-carotene was observed during the storage under 55℃. The chemical stability ofβ-carotene was improved when more than 1.00%α-LA was added as the emulsifier inβ-carotene emulsion. These results show thatα-LA can be a kind of good emulsifier and the proper amount of addition is 1.50% inβ-carotene emulsion. This study can be helpful to increaseβ-carotene utilization in food industry.

Effects of Milk Proteins on Release Properties and Particle Morphology of Β-Carotene Emulsions During in Vitro Digestion.

Investigation into the in Vitro Release Properties of Β-Carotene in Emulsions Stabilized by Different Emulsifiers

Formation, Stability and In Vitro Digestion of β-carotene in Oil-in-Water Milk Fat Globule Membrane Protein Emulsions

Investigation into the bioaccessibility and microstructure changes of β-carotene emulsions during in vitro digestion

Emulsifier Dependent in vitro Digestion and Bioaccessibility of β-Carotene Loaded in Oil-in-Water Emulsions

Comparison of Different Protein Emulsifiers on Physicochemical Properties of -Carotene-Loaded Nanoemulsion: Effect on Formation, Stability, and In Vitro Digestion

Comparison of Different Protein Emulsifiers on Physicochemical Properties of β-Carotene-Loaded Nanoemulsion: Effect on Formation, Stability, and In Vitro Digestion

Physicochemical Properties of Β-Carotene Bilayer Emulsions Coated by Milk Proteins and Chitosan–egcg Conjugates

Preparation of β-carotene Emulsion Stabilized by Beet Pectin-Whey Protein Isolate Complex and Its Digestion Properties in Vitro Digestion Model

Evaluation of Structural and Functional Properties of Protein–egcg Complexes and Their Ability of Stabilizing a Model Β-Carotene Emulsion

Characterization of -carotene loaded emulsion gels containing denatured and native whey protein

Effect of Solid Fat Content on Properties of Emulsion Gels and Stability of β-Carotene.

Physicochemical Properties and Chemical Stability of Β-Carotene Bilayer Emulsion Coated with Bovine Serum Albumin and Arabic Gum Compared to Monolayer Emulsions.

Absorption of Whey Protein Isolated (Wpi)-Stabilized Β-Carotene Emulsions by Oppositely Charged Oxidized Starch Microgels

Influence of Interfacial Compositions on the Microstructure, Physiochemical Stability, Lipid Digestion and Β-Carotene Bioaccessibility of Pickering Emulsions

Stability and Bioaccessibility of -Carotene in Oil in Water Emulsions: Impact of Antioxidant Type and Emulsifier

Bioaccessibility and Cellular Uptake of Β-Carotene Encapsulated in Model O/W Emulsions: Influence of Initial Droplet Size and Emulsifiers.

α-lactalbumin enhancing emulsion stability ofβ-carotene

Stability and Bioaccessibility of β‐Carotene in Oil in Water Emulsions: Impact of Antioxidant Type and Emulsifier

Influence of Whey Protein–beet Pectin Conjugate on the Properties and Digestibility of Β-Carotene Emulsion During in Vitro Digestion

Effects of Small and Large Molecule Emulsifiers on the Characteristics of Β-Carotene Nanoemulsions Prepared by High Pressure Homogenization