Abstract:OBJECTIVE:To study the effect of a modified alar base cinch suture (ABCS) based on nasal musculature anatomy on the three-dimensional morphology of nasolabial region in patients after Le Fort Ⅰ osteotomy. METHODS:In the study, 30 patients[11 males and 19 females, with an average age of (23.23±2.98) years]with skeletal Class Ⅲ malocclusion underwent orthognathic surgery between August, 2019 and January, 2020 to have the maxilla advanced no more than 4 mm in the Department of Oral and Maxillofacial Surgery, Peking University School and Hospital of Stomatology were involved and were divided into the test and control groups based on the random number table.In the test group, the nasal musculature was identified and labeled before dissection and the ABCS was according to the label, while in the control group, the nasal musculature was directly sutured and knotted in the midline of nose without prepend labeling.All the patients underwent three-dimensional facial photos preoperatively and 6 months postoperatively by using 3dMD face system.On the three dimensional image, soft tissue landmarks of nasolabial region was identified by the same examiner.Fourteen measurements including straight distance, curve distance, angle and ratio were measured.Statistical analysis was done by using SPSS 22.0. RESULTS:There were significant differences between the two groups in cutaneous height of upper lip (P=0.023) and in nasal tip protrusion-alar width (P=0.012).The increase rate of cutaneous height of upper lip and the decrease rate of nasal tip protrusion-alar width in the control group were significantly higher than that in the test group.The alar width and alar base width of the both groups were significantly increased compared with the preoperative level (P < 0.05).The nasolabial angle in the control group was significantly higher compared with the normal value, while there was no significant difference between the test group and the normal value. CONCLUSION:Compared with the conventional suture method, this modified alar base cinch suture is more favorable for the postoperative nasal coordination and nasolabial morphology in patients who need mild to moderate maxillary advancement, and it has certain advantages in operability and objective accuracy.So it could become a modified and accurate method of alar base cinch suture and be widely applied in clinical practice.

[Comparative Analysis of Two Surgical Techniques for Controlling Nasal Width after Le Fort I Osteotomy].

[Effect of Alar Base Cinch Suture Based on Anatomic Landmarks on the Morphology of Nasolabial Region in Patients after Orthognathic Surgery].

[Nasal Airway Changes after Maxillary Advancement Following Le Fort I Osteotomy].

Nasal Airway Evaluation after Le Fort I Osteotomy Combined with Septoplasty in Patients with Cleft Lip and Palate

[Changes of Different Section Area at Different Parts of Upper-Airway after Le Fort III Osteotomy].

Measurement and Evaluation of the Alar Base in Unilateral Secondary Lip Nasal Deformities by Three-Dimensional Computed Tomography

[Comparison of Allogenic Versus Ostetic Artificial Bone in Double Door Laminoplasty].

Nasal profile changes after LeFort I osteotomy (maxillary advancement) with and without ANS reduction in class III skeletal patients: a study protocol for a randomized clinical trial

Impact of Unilateral Alveolar Bone Grafting on Nasal Volume and Nasolabial Surface: A 3D Analysis

Changes in three-dimensional nasal morphology according to the direction of maxillary movement during Le Fort I osteotomy

Difference in the Surgical Outcome of Unilateral Cleft Lip and Palate Patients with and without Pre-Alveolar Bone Graft Orthodontic Treatment

Linear and angular measurement using cone-beam computed tomography to enhance safety in Le Fort I osteotomy with tuberosity cut

[Combined surgical and orthodontic treatment of severe maxillary anterior teeth and dentoalveolar bone protrusion].

[Transpalatal Modified Le Fort I Osteotomy for Correction of Maxillary Hypoplasia in Cleft Lip and Palate Patients: a Preliminary Clinical Application].

A cephalometric study on Le Fort Ⅲ osteotomy related anatomical features of anterior cranial base in syndromic craniosynostosis

Influence of marginal incision and Le Fort I osteotomy on periodontal tissues: a prospective longitudinal study

Analysis of thesubjective effect of endoscopic assisted nasal bone reduction

Reducing the Risk of Unfavorable Fractures in Le Fort III Osteotomy Via a Navigation-Guided Technique

Effect of the Presurgical Nasoalveolar Molding Using Computer-Aided Design Technique

An Innovative Method for Nasal Alar Reduction Surgery Based on the Equilateral Triangle Design Theory

Postoperative maxillary stability after Le Fort I osteotomy using a u-HA/PLLA system: three-dimensional analysis by surface superimposition based on virtual Le Fort I osteotomy