Abstract:Objective To investigate the effectiveness of rapid prototyping (RP) technique manufactured Poly (DL-lactic-co-glycolic acid)/Tricalcium phosphate (PLGA/TCP) loaded with bovine morphogenetic protein (bBMP)as a new graft material for spinal fusion in an animal model. Methods Firstly, three-dimensional PLGA/TCP granular scaffolds were synthesized by RP and bBMP was loaded into the granular scaffolds. Secondly, both PLGA/TCP scaffolds and PLGA/TCP-bBMP composites were observed by scanning electron microscopy. Thirdly, 42 healthy New Zealand white rabbits weighing 2-2.5 kg (four months old) unilaterally underwent posterior interlaminar spine fusion at the L_ 2~4 level (on the left side) using one of the following graft materials: RP synthesized PLGA/TCP granules (Group A, 14 rabbits), PLGA/TCP-bBMP composites (Group B, 14 rabbits) and autogenous iliac bone graft (Group C, 14 rabbits). The animals in each group were killed at the end of 4th week (two animals), 8th week (two animals) and 12th week (10 animals) after surgery. The spine fusion was evaluated by a general observation, a manual palpation test, histological analyses and radiography. Results RP technique established PLGA/TCP scaffolds with good biomaterial properties including satisfactory microstructure and porosities. bBMP was efficiently loaded into the granular scaffolds to produce a new biomimetic artificial grafting material. In Group A, histological analyses revealed that PLGA/TCP scaffolds were biocompatible and biodegradable. Whereas, no newly formed bone was found within and in contact with the implanted granules. In Group B, highly cellular bone marrow between the newly formed trabecular bone were present in the fusion mass. In Group C, there was a reduced amount of newly formed bone at 12th week compared with Group B. Twelve weeks after surgery, the fusion rate of posterior interlaminar arthrodesis (at L_ 2,3 and L_ 3,4 ) in Group A, B and C was 0% (0/20), 90% (18/20) and 55% (11/20), respectively. The fusion rate in Group B was significantly higher than that in Group C (P0.05) and the fusion rate in Group C was significantly higher than that in Group A (P0.01). Conclusions Extracted bovine bone morphogenetic protein can be in vitro efficiently loaded into RP technique manufactured PLGA/TCP scaffolds to make a new graft material for spinal fusion. RP-based PLGA/TCP-bBMP composites appear to be more effective for multiple spine arthrodesis than autogenous bone grafts. Therefore, the biomemetic artificial grafting material is a promising novel tool for spine surgery. Further studies are required to confirm the medium- to long-term results.

Accelerated Postero-Lateral Spinal Fusion By Collagen Scaffolds Modified With Engineered Collagen-Binding Human Bone Morphogenetic Protein-2 In Rats

Evaluation of Bone Regeneration by Β Tricalcium Phosphate/Collagen Scaffold Loaded with Bone Morphogenetic Proteins 2 Plasmid in Rat Cranial Defect

An Effective Delivery Vehicle of Demineralized Bone Matrix Incorporated with Engineered Collagen-Binding Human Bone Morphogenetic Protein-2 to Accelerate Spinal Fusion at Low Dose

CALCIUM SULFATE/HYDROXYAPATITE-MEDIATED CONTROLLED CO-DELIVERY OF BMP-2 AND ZOLEDRONIC ACID ENHANCES SPINAL FUSION

Lumbar Spinal Fusion with a Mineralized Collagen Matrix and Rhbmp-2 in a Rabbit Model.

Improved Posterolateral Lumbar Spinal Fusion Using a Biomimetic, Nanocomposite Scaffold Augmented by Autologous Platelet-Rich Plasma

A supramolecular polymer-collagen microparticle slurry for bone regeneration with minimal growth factor

Bone morphogenetic protein-2 induced posterolateral lumbar fusion in a mouse model

Bone Regeneration by Controlled Release of Bone Morphogenetic Protein-2: A Rabbit Spinal Fusion Chamber Molecular Study.

Co-delivery of rhBMP-2 and zoledronic acid using calcium sulfate/hydroxyapatite carrier as a bioactive bone substitute to enhance and accelerate spinal fusion

Experimental Posterior Interlaminar Spinal Fusion in Rabbits with a New Biomimetic Grafting Material

Synergistic enhancement of spinal fusion in preclinical models using low-dose rhBMP-2 and stromal vascular fraction in an injectable hydrogel composite

Intervertebral Spinal Fusion Using A Rp-Based Plga/Tcp/Bbmp Biomimetic Grafting Material

The bone morphogenetic protein 2 analogue L51P enhances spinal fusion in combination with BMP2 in an in vivo rat tail model

Development of gelatin-methacryloyl composite carriers for bone morphogenetic Protein-2 delivery: A potential strategy for spinal fusion

Hybrid multilayer coating as the psoralen delivery vehicle promoting bone regeneration on titanium mesh scaffolds in a Posterolateral Spinal Fusion model

Application of glue-like E-matrix in posterolateral spinal fusion of rats

GDF-5 Variant Loading on Composite Scaffolds Promotes Spinal Fusion Through Coupling of Osteogenesis and Angiogenesis: a Preclinical Study in Rhesus Monkeys

Experimental Posterolateral Spinal Fusion in Rabbits with a PLGA/TCP/Col/ADSCs-OB Biomimetic Grafting Material

Experimental Study of Rabbit's Spinal Fusion Promoted by RGD Modified Mimetic Periosteum Combined with Nanoscale Osteoinductive Bone

NELL-1 Based Demineralized Bone Graft Promotes Rat Spine Fusion As Compared to Commercially Available BMP-2 Product