Abstract:Hydrogenolysis of biomass-derived glycerol is an alternative route to sustainable production of propylene glycol. Cu–ZnO catalysts were prepared by coprecipitation with a range of Cu/Zn atomic ratio (0.6–2.0) and examined in glycerol hydrogenolysis to propylene glycol at 453–513 K and 4.2 MPa H 2 . These catalysts possess acid and hydrogenation sites required for bifunctional glycerol reaction pathways, most likely involving glycerol dehydration to acetol and glycidol intermediates on acidic ZnO surfaces, and their subsequent hydrogenation on Cu surfaces. Glycerol hydrogenolysis conversions and selectivities depend on Cu and ZnO particle sizes. Smaller ZnO and Cu domains led to higher conversions and propylene glycol selectivities, respectively. A high propylene glycol selectivity (83.6%), with a 94.3% combined selectivity to propylene glycol and ethylene glycol (also a valuable product) was achieved at 22.5% glycerol conversion at 473 K on Cu–ZnO (Cu/Zn = 1.0) with relatively small Cu particles. Reaction temperature effects showed that optimal temperatures (e.g. 493 K) are required for high propylene glycol selectivities, probably as a result of optimized adsorption and transformation of the reaction intermediates on the catalyst surfaces. These preliminary results provide guidance for the synthesis of more efficient Cu–ZnO catalysts and for the optimization of reaction parameters for selective glycerol hydrogenolysis to produce propylene glycol.

Highly Efficient Conversion of Biomass-Derived Glycolide to Ethylene Glycol over CuO in Water.

Conversion of Biomass-Derived Glycolide to Ethylene Glycol over Cu

Oxidative Lactonization of Diethylene Glycol to High-Value-added Product 1, 4-Dioxan-2-one Promoted by a Highly Efficacious and Selective Catalyst ZnO-ZnCr2O4

Heterogeneous Cu2O-mediated Ethylene Glycol Production from Dimethyl Oxalate

A novel approach for 1,2-propylene glycol production from biomass-derived lactic acid

Oxidant-Free Transformation of Ethylene Glycol Toward Glycolic Acid in Water

Ethylene glycol and ethanol synthesis from dimethyl oxalate hydrogenation on the Cu/ZnO/SiO2 catalysts

Selective hydrogenolysis of glycerol to propylene glycol on Cu–ZnO catalysts

Selective Hydrogenolysis of Xylitol to Ethylene Glycol and Propylene Glycol over Silica Dispersed Copper Catalysts Prepared by a Precipitation–Gel Method

Hydrothermal Conversion of Ethylene Carbonate to Ethylene Glycol

One-Step Electrochemical Ethylene-to-Ethylene Glycol Conversion over a Multitasking Molecular Catalyst.

Copper Supported on MgAlOx and ZnAlOx Porous Mixed-Oxides for Conversion of Bioethanol via Guerbet Coupling Reaction

Hydrogenation Of Dimethyl Oxalate To Ethylene Glycol Over Cu/Sio2 Catalysts

Production of Ethylene Glycol and Its Monoether Derivative from Cellulose

Cu/Sio2 Catalysts Prepared by the Sol-Gel Method for Hydrogenation of Dimethyl Oxalate to Ethylene Glycol

Catalytic conversion of cellulose for efficient ethylene glycol production and insights into the reaction pathways

Efficient Hydrogenation of Dimethyl Oxalate to Ethylene Glycol Via Nickel Stabilized Copper Catalysts

Catalytic Conversion of Cassava Residues to Ethylene Glycol Via a One-Pot Hydrothermal Reaction

Photodehydration of Ethanol Mediated by CuCl 2 -Ethanol Complex

Oxidation of Ethylene Glycol to Glycolaldehyde Using a Highly Selective Alcohol Dehydrogenase from Gluconobacter Oxydans

Ultra-stable Cu-based catalyst for dimethyl oxalate hydrogenation to ethylene glycol