Abstract:The design of the microstructure distribution on the bottom surface of the partial integrated light guide plate (PILGP) is one of the key factors to improve the luminance uniformity of the partial integrated backlight module (BLM). In this paper, the two-dimensional micro-prism expressions on the bottom surface of the small-sized PILGP are presented. The two-dimensional micro-prism expressions make the micro-prisms spread out on a two-dimensional scale of the bottom surface of the PILGP. By fitting and analyzing a large number of simulation data, the relationship expressions between the coefficients of the two-dimensional micro-prism expressions and the structural parameters of the PILGP are established. The above expressions are directly applied to the two-dimensional distribution design of micro-prism on the bottom surface of small-sized PILGPs with different structural parameters. Without the help of the designers' experience and the multiple simulations of the software, the average value of luminance uniformity in the partial integrated BLMs is obtained to be 84.94%. The simulation results show that the two-dimensional micro-prism expressions and coefficient relation-expressions presented in this paper have important application value. Take the 5-inch partial integrated BLM for example. The two-dimensional distribution of the micro-prism on the bottom surface of the PILGP with high luminance uniformity can be obtained directly by using the above expressions. By fine-tuning the coefficients of two-dimensional micro-prism expressions, calculated by the coefficient relation-expressions, the utilization of light energy, illuminance uniformity and luminance uniformity of the partial integrated BLM respectively reach 90.69%, 88.02% and 92.17%, which meet the practical requirements. The optimization and design time of the partial integrated BLM are both greatly saved. Further, the two-dimensional micro-prism expressions on the bottom surface of the PILGP are analyzed and the physical mechanism is explained reasonably. This work is of significance for the distribution design of the microstructures on the surface of the LGP.

Algorithm research on microstructure distribution on the bottom surface of an integrated micro-optical light guide plate.

Research of Micro-Prism Distribution on the Bottom Surface of the Small-Size Integrated Light Guide Plate

Two-dimensional Distribution Design of Micro-Prism for Partial Integrated Light Guide Plate

Algorithm Optimization and Mask Data Generating for Dammann Gratings in Laser Medical Applications

Design and Optimization of a Partial Integrated Backlight Module

Technological Processes of Grating Light Valve As Diffractive Spatial Light Modulator in Laser Phototypesetting System

Study on the optical performance of light guide plate with pyramid-shaped microstructures

Regular Dot Pattern of Light Guide Used in Liquid Crystal Display Backlight

Novel integrated light-guide plates for liquid crystal display backlight

High Quality Light Guide Plates That Can Control the Illumination Angle Based on Microprism Structures

Optical Performance of Secondary Lightguide-Diffusive Component in Direct LED Backlight Module

The Dependence of Light Extraction Improvement on Optimized Surface Microstructure for AlGaN-based UVC-LEDs Considering TM-polarized Emission

Enhanced Light Extraction by Optimizing Surface Microstructure for AlGaN-based Deep Ultraviolet Light Emitting Diodes with 265 and 280 Nm Emission

Edge/direct-lit Hybrid Mini-Led Backlight with U-grooved Light Guiding Plates for Local Dimming.

Optical Simulation Design of Surface Mounted Device Beads for Wide Beam and High Uniformity Display

Optical design in illumination system of digital light processing projector using laser and gradient-index lens

Design and Optimization of Dot-Pattern for Large Scale LED Backlight Unit

Growth and Characterization of Micro-LED Based on GaN Substrate

The use of roll-to-plate UV-curing embossing to produce a composite light guide plate

Use of Adjusted Molecular Dynamics Method for Dot Pattern Design in Large Scale Light-Emitting Diode Edge-Lit Backlight Unit

Optimization of optical uniformity factors of backlight module using robust design method