Abstract:Development of high-performance NO2 gas sensors with good sensitivity and long-term stability at high tem-peratures is expected for exhaust gas monitoring. The sensor performance mainly depends on sensing material. In this work, p-NiO/n-NiNb2O6 heterojunction material is successfully synthesized and an impedimetric NO2 sensor was assembled using the above material as sensing electrode (SE) and gadolinia-doped ceria (CGO) with a dense/ porous bilayer structure as a solid electrolyte. Introduction of SE to the CGO porous layer by screen printing followed by cold isostatic pressing treatment before calcination allows SE to successfully enter inside the porous layer and greatly increases the area of the three-phase boundary (TPB) and improves the long-term stability of the sensor. Using NiO/NiNb2O6 heterojunction SE can effectively improve the modulus (|Z|) response value (S|Z| = (|Z|air -|Z|gas)/|Z|air) of the sensor. Among the sensors, 90NiO/10NiNb2O6 (the mass ratio of NiO to Nb2O5 is 9:1) based NO2 sensor exhibits the best response performance and the highest sensitivity (0.34/ppm at 500 degrees C). The sensor also shows an excellent anti-interference property. Introduction of 300 ppm CO2, CH4, NO, CO, or H2 into 300 ppm NO2 makes response signal change below 3 % and 300 ppm NH3 only leads to signal reduction by 8.9 %, which is relatively low in a similar sensing system. The sensor response toward NO2 is slightly affected by O2 concentration change in 5-21 %. The superior performance of the sensor can be principally attributed to the heterojunction effect, which promotes the charge transfer and the adsorption capacity for NO2.

Plate-like P–n Heterogeneous NiO/WO3 Nanocomposites for High Performance Room Temperature NO2 Sensors

Plate-like p-n heterogeneous NiO/WO₃ nanocomposites for high performance room temperature NO₂ sensors

WO3 Nanosheet/W18O49 Nanowire Composites for NO2 Sensing

Enhanced gas-sensing performance of SnO2/Nb2O5 hybrid nanowires

Two-dimensional Cd-doped Porous Co3O4 Nanosheets for Enhanced Room-Temperature NO2 Sensing Performance

Sensing Properties and Mechanism of Gas Sensors Based on Room-Temperature Solution Processed NiO-Ni v Nanoparticles

Pompon-like Ni doped ZnO mesoporous microspheres for conductometric NO 2 sensing properties at room temperature

Edge-enriched MoS2 Nanosheets Modified Porous Nanosheet-Assembled Hierarchical In2O3 Microflowers for Room Temperature Detection of NO2 with Ultrahigh Sensitivity and Selectivity.

Designing One-Dimensional Hierarchical Cu@Cu2O/CuO Core-Shell Heterostructure for Highly Sensitive Detection of NO2 at Room Temperature

An Ultrasensitive NO 2 Gas Sensor Based on a NiO-SnO 2 Composite with a Sub-ppb Detection Limit at Room Temperature

Confined Formation of Ultrathin ZnO Nanorods/Reduced Graphene Oxide Mesoporous Nanocomposites for High-Performance Room-Temperature NO 2 Sensors.

Two-dimensional NiO nanosheets with enhanced room temperature NO 2 sensing performance via Al doping.

Novel synthetic strategy towards NiO/Ni3N composite hollow nanofibers for superior NOx gas-sensing properties at room temperature

Electrodeposited Tungsten Oxide Films Onto Porous Silicon for NO2 Detection at Room Temperature

Highly sensitive NO2 sensor based on mesoporous ZrO2–WO3 nanotubes composite

Cu-MOF-74-derived Cu2O/CuO-C nanocomposite as an effective chemiresistive sensor for detection of NO2 at room temperature

In-situ Construction of SnO2 Nanolayer-Sns2 Nanosheets Heterostructures for Enhanced NO2 Sensing at Room Temperature and Their DFT Investigation

Nanowires-assembled WO3 nanomesh for fast detection of ppb-level NO2 at low temperature

Highly active and porous single-crystal In<sub>2</sub>O<sub>3</sub> nanosheet for NO<sub>x</sub> gas sensor with excellent response at room temperature

Enhanced Room Temperature NO2 Sensing Performance Based on N-doped Carbon Nanosheets@zno Nanoplates by Morphology Transition and White Light Illumination

Impedimetric-type NO2 Sensor Based on the P-Nio/n-ninb2o6 Heterojunction Sensing Electrode