Abstract:Lithium-O2 battery as a novel energy conversion and storage device has attracted increasing attention [1]. However, it’s still facing great challenges for practical applications, including of large over potentials, poor cycling life [2]. Many reports have shown that a suitable cathode catalyst may could solve these problems [3]. Herein, metal sulfide (NiCo2S4) nanotube arrays on carbon paper were synthesized through a two-step hydrothermal method and then applied as a freestanding, binder-free cathode for lithium-O2 batteries directly. This novel air electrode could deliver a high initial discharge capacity of 12348.5 mAh g-1 with coulomb efficiency of 88.9% (Fig. 1a). Specifically, the discharge/charge over-potentials gap has been reduced to 0.73V, which is much lower than that of the counterpart metal oxide catalyst (NiCo2O4 NWs, 1.24 V)(Fig. 1b). Furthermore, this NiCo2S4 NTs@CFPs air electrode shows excellent long cycling life (485 cycles). This novel air electrode also exhibited great stability and reversibility. Interestingly, the discharge product of the air electrode with NiCo2S4 NTs is film-like amorphous Li2O2, which owns higher charge-transport properties and could be decomposed at a much lower potential than the common crystalline Li2O2. The excellent cell performances could be ascribed to the intrinsic properties of NiCo2S4, including high electrical conductivity and redox activity, the special hollow nanotubes structure, which could provide larger specific surface area and more active sites as well as enough space to accommodate the discharge products. The numerous pores distributed on the nanotube wall could also facilitate the transport of oxygen and electrolyte during the cell operation. This novel freestanding, binder-free air electrode sheds light on the application of metal sulfides not only on Lithium-air batteries, but also other metal-air batteries and fuel cells. This work was supported by National Natural Science Foundation of China (21673153, 21303114，51272167 and 51572181 ), National Key Research and Development Program of China (2016YFB0100200), Natural Science Foundation of the Higher Education Institutions of Jiangsu Province, China (15KJB480001) and Natural Science Foundation of Jiangsu Province, China (BK20161207). References: 1. Bruce P.G., Freunberger S.A., Hardwick L.J., Tarascon J.M. (2012). Li-O2 and Li-S batteries with high energy storage. Nat. Mater., 11, 19-29. 2. Li F.J., Zhang T., Zhou H.S. (2013). Challenges of non-aqueous Li-O2 batteries: electrolytes, catalysts, and anodes. Energy Environ. Sci., 6, 1125-1141. 3. Shao Y.Y., Park S., Xiao J., Zhang J.-G., Wang Y., Liu J. (2012). Electrocatalysts for nonaqueous lithium-air batteries: status, challenges, and perspective. ACS Catal., 2, 844-857. Figure 1

Vertically Aligned N-Doped Coral-Like Carbon Fiber Arrays As Efficient Air Electrodes For High-Performance Nonaqueous Li-O-2 Batteries

The Free-Standing N-CoO Matrix Towards Optimizing Dual-Electrodes for High-Performance Li-O2 Batteries

In Situ CVD Derived Co-N-C Composite As Highly Efficient Cathode for Flexible Li-O2 Batteries.

Nitrogen-Doped Holey Graphene for High-Performance Rechargeable Li–O2 Batteries

Electron-redistributed Ni-Co Oxide Nanoarrays As an ORR/OER Bifunctional Catalyst for Low Overpotential and Long Lifespan Li-O2 Batteries

Preparation of A New Carbon Nanofiber As A High-Capacity Air Electrode for Nonaqueous Lithium-Oxygen Batteries

Electron redistributed Ni-Co oxide nanoarray as an ORR/OER bifunctional catalyst for low overpotential and long lifespan Li-O2 batteries

Freestanding, Binder-Free Metal Sulfide Nanotubes Array As High Efficient Cathode for High Performance Lithium-O2 Batteries

Vertically Aligned N-doped Carbon Nanotubes Arrays as Efficient Binder-free Catalysts for Flexible Li-CO2 Batteries

Constructing An Interlaced Catalytic Surface Via Fluorine‐doped Bimetallic Oxides for Oxygen Electrode Processes in Li–O2 Batteries

Efficient Bifunctional Catalytic Electrodes with Uniformly Distributed NiN2 Active Sites and Channels for Long-Lasting Rechargeable Zinc-Air Batteries.

Design and Synthesis of Hierarchical, Freestanding Bowl-Like NiCo2O4 As Cathode for Long-Life Li-O-2 Batteries

Hierarchical Carbon–Nitrogen Architectures with Both Mesopores and Macrochannels As Excellent Cathodes for Rechargeable Li–O2 Batteries

Configuration of Gradient-Porous Ultrathin FeCo2S4 Nanosheets Vertically Aligned on Ni Foam As a Noncarbonaceous Freestanding Oxygen Electrode for Lithium-Oxygen Batteries.

N, F Co‐Doped Carbon Material Self‐Supporting Cathode for High‐Performance Lithium‐Oxygen Batteries

Highly-efficient MnO2/carbon Array-Type Catalytic Cathode Enabling Confined Li2O2 Growth for Long-Life Li–O2 Batteries

In-situ Nitrogen-Doped Hierarchical Porous Hollow Carbon Spheres Anchored with Iridium Nanoparticles As Efficient Cathode Catalysts for Reversible Lithium-Oxygen Batteries

A High-Performance Lithium Ion Oxygen Battery Consisting of Li2o2 Cathode and Lithiated Aluminum Anode with Nafion Membrane for Reduced O-2 Crossover

Hierarchical Porous Nickel Cobaltate Nanoneedle Arrays as Flexible Carbon-Protected Cathodes for High-Performance Lithium-Oxygen Batteries

In-situ Cobalt-Nickel Alloy Catalyzed Nitrogen-Doped Carbon Nanotube Arrays As Superior Freestanding Air Electrodes for Flexible Zinc-Air and Aluminum-Air Batteries

Binder-free NiFe 2 O 4 /C Nanofibers As Air Cathodes for Li-O 2 Batteries