Abstract:A novel core-shell magnetic composites [Fe3O4@C@FeOx (FCF)] (Fe3O4 as the core and C as the inner shell, FeOx as the outer shell) was prepared by modifying Fe3O4@C magnetic nanoparticles (FC) by amorphous iron oxides to remove As(V) from water. Both the magnetic core (FC) and the amorphous iron oxide shell were all fabricated with Iron-containing water treatment residuals (WTRs), also called iron sludge. X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), transmission electron microscopy (TEM), Brunauer-Emmett-Teller analysis (BET), X-ray photoelectron spectroscopy (XPS) and vibrating sample magnetometer (VSM) were utilized to characterize the FC and FCF. TEM images clearly show that FCF is composed of spherical particles with obvious core-shell structure, and the thickness of carbon shell and amorphous iron oxide shell are 20-35 and 30-50 nm, respectively. With saturation magnetization of 16.30 emu/g, FCF nanoparticles could be easily separated from the solution with a hand held magnet. BET analysis show that the specific surface area of FCF is 122.7 m(2)/g, which is conducive to the adsorption of As(V). The adsorption efficiency of FCF for As(V) is high in a wide range of pH 3-9. Moreover, the adsorption process might be a chemical adsorption according to kinetics fitting analysis of FCF. Both Langmuir and Freundlich model could fit the adsorption data for the FCF at 25 degrees C and 35 degrees C well, and the maximum adsorption capacity of FCF (13.47 mg/g) at 25 degrees C is about 3.29 times of that of FC (3.14 mg/g), which may be due to the large amount of amorphous iron oxides coated on the surface of FCF and its large specific surface area. This study not only provides a new way for the disposal of waste iron sludge, but also supplies a cheap and stable adsorbent for the treatment of arsenic-containing water.

Removal of Humic Substances Using Cerium-Iron Adsorbent

Preparation and Adsorption Mechanism of Rare Earth-Doped Adsorbent for Arsenic(v) Removal from Groundwater

REMOVAL OF FLUORIDE USING RARE EARTH BASED INORGANIC ADSORBENT

Removal of Fulvic Acid from Water Electrochemically Using Active Carbon Fiber Electrode

ADSORPTION OF ARSENIC FROM DRINKING WATER ON RARE EARTH BASED INORGANIC ADSORBENT

Arsenic(V) Removal with a Ce(IV)-doped Iron Oxide Adsorbent.

Adsorption of Fulvic Acid by Carbon Nanotubes from Water.

Determination of main influence mechanism of fulvic acid on arsenic removal by ferric chloride

Enhanced As (V) Removal from Aqueous Solution by Biochar Prepared from Iron-Impregnated Corn Straw

Landfill Leachate Pretreatment by Coagulation–flocculation Process Using Iron-Based Coagulants: Optimization by Response Surface Methodology

Zeolite-based absorbent: Polyacrylic acid loading for enhanced ferric(III) removal from aqueous solution

Enhanced removal of As (V) from aqueous solution using modified hydrous ferric oxide nanoparticles

The performance of Fe2+/ClO− system in advanced removal of fulvic acid under mild conditions

Adsorption of Cerium (III) by HKUST-1 Metal-Organic Framework from Aqueous Solution

Removal of arsenate with hydrous ferric oxide coprecipitation: effect of humic acid

Removal of As(III) and As(V) from Water Using Iron Doped Amino Functionalized Sawdust: Characterization, Adsorptive Performance and UF Membrane Separation

Leaching mechanisms of constituents from fly ash under the influence of humic acid

Reduction of Fulvic Acid in Drinking Water by Ferrate

Removal of As(V) by a Core-Shell Magnetic Nanoparticles Synthesized with Iron-Containing Water Treatment Residuals

Adsorption, kinetics and thermodynamics studies on removal of humic acid by fly ash

Coagulation of Arsenic Adsorbed Ferrihydrite with the Use of Polyaluminium Chloride (PAC) or Polyferric Sulfate (PFS)