Abstract:Fiber Bragg grating optical sensors are nowadays widely employed for strain measurement for structural health monitoring and in experimental mechanics. Compared to other techniques, i.e. electrical strain gauges, fiber Bragg grating offer immunity to electromagnetic interference and allow for long transmission lead lines. Moreover, thanks to multiplexing interrogation, several sensors can be photo-imprinted into a single fiber core allowing for strain evaluation at multiple locations simultaneously. They have high adaptability to composite materials, particularly because it is possible to be embedded into laminates without affecting their strength and stiffness. Fiber Bragg grating strain measurements are based on the detection of the wavelength shift of their peak reflected spectrum. However, subjected to strain gradients, the spectral response of fiber Bragg grating sensors may be distorted and the sharp peak may not be retained. In this work, the response of fiber Bragg grating sensors having different grating lengths and bonded to the surface of a carbon fiber-reinforced twill woven laminate was analyzed. The analysis combined transfer matrix (T-matrix) with digital image correlation methods. Digital image correlation technique was used to capture the non-uniform strain fields in the woven composites and measured strains were employed in T-Matrix algorithm to simulate fiber Bragg grating response. Using this approach, the effect of the length of the fiber Bragg grating on the strain measurement is assessed and results discussed. Moreover, it is shown that T-matrix formulation combined with a non-contact strain field measurement technique, as DIC, is an appropriate technique to simulate the behavior of fiber Bragg grating bonded to composite materials of complex microstructure.

Strain Sensing of Modern Composite Materials with A Spatial Wavelength-Division Multiplexed Fiber Grating Network

Embedded fibre Bragg grating sensors for non-uniform strain sensing in composite structures

High-speed Quasi-Distributed Strain Sensing Based on Time Division Multiplexing of Fibre Bragg Gratings

Multi-Directional Strain Measurement in Fiber-Reinforced Plastic Based on Birefringence of Embedded Fiber Bragg Grating

Experimental analysis of the response of fiber Bragg grating sensors under non-uniform strain field in a twill woven composite

Multiplexed Static FBG Strain Sensors by Dual-Comb Spectroscopy with a Free Running Fiber Laser

Fiber Optic Sensing Textile for Strain Monitoring in Composite Substrates

Static Pure Strain Sensing Using Dual-Comb Spectroscopy with FBG Sensors.

Simultaneous measurement of dynamic displacement and strain in a single fiber using coarse wavelength-division multiplexing and fiber Bragg-grating filter-based sensing system

Multiplexed static FBG strain sensors by dual-comb spectroscopy with a free running fiber laser.

Compact Interrogation System of Fiber Bragg Grating Sensors Based on Multiheterodyne Dispersion Interferometry for Dynamic Strain Measurements

A Multiplexed Optical Fiber Sensor System For Distributed Measurement Of Structural Strains

Dynamic strain measurement using two wavelength-matched fiber Bragg grating sensors interrogated by a cascaded long-period fiber grating

Strain Measurement for Composite Materials During Mechanical Testing Based on Fiber Bragg Grating Monitoring

Temperature-controlled Fiber Bragg Grating Dynamic Strain Detection System

Multifunctional Fiber Bragg Grating sensing system for load monitoring of composite wings

Strain sensor system based on a high finesse fiber Bragg grating Fabry-Perot cavity

A Novel Strain Sensor Based on a Pair of Fiber Bragg Grating Comb Filters

Fiber Bragg Grating Sensors toward Structural Health Monitoring in Composite Materials: Challenges and Solutions

Distributed strain interrogation with a linearly chirped fiber Bragg grating based on an optoelectronic oscillator