Abstract:Conformal optical domes are characterized as having external more elongated optical surfaces that are optimized to minimize drag, increased missile velocity and extended operational range. The outer surface of the conformal domes typically deviate greatly from spherical surface descriptions, so the inherent asymmetry of conformal surfaces leads to variations in the aberration content presented to the optical sensor as it is gimbaled across the field of regard, which degrades the sensor's ability to properly image targets of interest and then undermine the overall system performance. Consequently, the aerodynamic advantages of conformal domes cannot be realized in practical systems unless the dynamic aberration correction techniques are developed to restore adequate optical imaging capabilities. Up to now, many optical correction solutions have been researched in conformal optical design, including static aberrations corrections and dynamic aberrations corrections. There are three parts in this paper. Firstly, the combination of static and dynamic aberration correction is introduced. A system for correcting optical aberration created by a conformal dome has an outer surface and an inner surface. The optimization of the inner surface is regard as the static aberration correction; moreover, a deformable mirror is placed at the position of the secondary mirror in the two-mirror all reflective imaging system, which is the dynamic aberration correction. Secondly, the using of appropriate surface types is very important in conformal dome design. Better performing optical systems can result from surface types with adequate degrees of freedom to describe the proper corrector shape. Two surface types and the methods of using them are described, including Zernike polynomial surfaces used in correct elements and user-defined surfaces used in deformable mirror (DM). Finally, the Adaptive optics (AO) correction is presented. In order to correct the dynamical residual aberration in conformal optical design, the SPGD optimization algorithm is operated at each zoom position to calculate the optimized surface shape of the MEMS DM. The communication between MATLAB and Code V established via ActiveX technique is applied in simulation analysis.

Design of Fixed Correctors Used in Conformal Optical System Based on Diffractive Optical Elements.

Conformal Dome Aberration Correction with Gradient Index Optical Elements.

Conformal Dome Aberration Correction by Designing the Inner Surface

Conformal Optical Design with Combination of Static and Dynamic Aberration Corrections

The Research of Conformal Optical Design

Design and Study of Conformal Optics

Conformal Optical Design Using Counterrotating Wedges and Zernike Fringe Sag Surfaces

Conformal dome correction with counterrotating phase plates

Design of Infrared Optical System with Special Dome

Optimized Design Method for the Inner Surface of a Conformal Dome Based on the Ray Tracing Approach.

Research on aberration correction methods of conformal dome based on Haack curve

Design of reflective lens with Zernike polynomial free form surfaces

Research of Aberration Characteristics of Conicoidal Conformal Optical Domes

Adjustment on the Received Optical Power of a Ground-Based Optical Instrument by a Corner Cube Retroreflector with a Curved Front-Face.

Conformal Optical Design Using Counterrotating Wedges and Zernike Polynomial

The Suppression of Aero-Optical Aberration of Conformal Dome by Wavefront Coding

Optical System Design of Telescope Based on Mixed Modulation Diffractive Lens

Method to Design Two Aspheric Surfaces for a Wide Field of View Imaging System with Low Distortion

Aerodynamic heating of the dome on imaging quality degradation of conformal optical systems

Aberration Characteristic Correlation Configuration Optimization of a Conformal Dome Based on the Von Karman Surface

The Dynamic Aberrations Suppression of Conformal Optical System by Wavefront Coding