Abstract:Low solution conductivity is known to adversely impact power generation in microbial fuel cells (MFCs), but its impact on measured electrode potentials has often been neglected in the reporting of electrode potentials. While errors in the working electrode (typically the anode) are usually small, larger errors can result in reported counter electrode potentials (typically the cathode) due to large distances between the reference and working electrodes or the use of whole cell voltages to calculate counter electrode potentials. As shown here, inaccurate electrode potentials impact conclusions concerning factors limiting power production in MFCs at higher current densities. To demonstrate how the electrochemical measurements should be adjusted using the solution conductivity, electrode potentials were estimated in MFCs with brush anodes placed close to the cathode (1 cm) or with flat felt anodes placed further from the cathode (3 cm) to avoid oxygen crossover to the anodes. The errors in the cathode potential for MFCs with brush anodes reached 94 mV using acetate in a 50 mM phosphate buffer solution. With a felt anode and acetate, cathode potential errors increased to 394 mV. While brush anode MFCs produced much higher power densities than flat anode MFCs under these conditions, this better performance was shown primarily to result from electrode spacing following correction of electrode potentials. Brush anode potentials corrected for solution conductivity were the same for brushes set 1 or 3 cm from the cathode, although the range of current produced was different due to ohmic losses with the larger distance. These results demonstrate the critical importance of using corrected electrode potentials to understand factors limiting power production in MFCs.

Controlling the Occurrence of Power Overshoot by Adapting Microbial Fuel Cells to High Anode Potentials

Power Overshoot in Two-Chambered Microbial Fuel Cell (Mfc)

Occurrence of Power Overshoot for Two-Chambered Mfc at Nearly Steady-State Operation

Enhance Cathodic Capacitance to Eliminate Power Overshoot in Microbial Fuel Cells

Effect of Anodic Biofilm Growth on the Performance of the Microbial Fuel Cell (MFC)

A new insight into potential regulation on growth and power generation of Geobacter sulfurreducens in microbial fuel cells based on energy viewpoint.

Anode Modification with Capacitive Materials for a Microbial Fuel Cell: an Increase in Transient Power or Stationary Power

Performance of a Batch Two‐chambered Microbial Fuel Cell Operated at Different Anode Potentials

Evaluation of Applied Cathode Potential to Enhance Biocathode in Microbial Fuel Cells

[Effect of the Initial Anode Potential on Electricity Generation in Microbial Fuel Cell].

Enhanced Electricity Generation of a 1.2-L Microbial Fuel Cell with Acclimation of Applied Voltage

Response of Anodic Biofilm and the Performance of Microbial Fuel Cells to Different Discharging Current Densities.

Multiparameter optimization of microbial fuel cell outputs using linear sweep voltammetry and microfluidics

Asymmetric Reactors As an Innovative Approach for Optimum Microbial Fuel Cells Performance

Intermittent Contact of Fluidized Anode Particles Containing Exoelectrogenic Biofilms for Continuous Power Generation in Microbial Fuel Cells

Power generation in fed-batch microbial fuel cells as a function of ionic strength, temperature, and reactor configuration.

The Impact of Ohmic Resistance on Measured Electrode Potentials and Maximum Power Production in Microbial Fuel Cells.

Optimization of Microbial a Fuel Cell with Linear Sweep Voltammetry and Microfluidics

Development of Microbial Community Within the Cathodic Biofilm of Single-Chamber Air-Cathode Microbial Fuel Cell.

Analysis and characterization of bioanodes incubated via constant current in a microbial fuel cell

Increased Power Generation in a Continuous Flow MFC with Advective Flow Through the Porous Anode and Reduced Electrode Spacing