Role of Dopant Concentration, Crystal Phase and Particle Size on Microbial Inactivation of Cu-doped TiO2 Nanoparticles.

Manoranjan Sahu,Bing Wu,Liying Zhu,Craig Jacobson,Wei-Ning Wang,Kristen Jones,Yogesh Goyal,Yinjie J. Tang,Pratim Biswas

DOI: https://doi.org/10.1088/0957-4484/22/41/415704

IF: 3.5

2011-01-01

Nanotechnology

Abstract:The properties of Cu-doped TiO(2) nanoparticles (NPs) were independently controlled in a flame aerosol reactor by varying the molar feed ratios of the precursors, and by optimizing temperature and time history in the flame. The effect of the physico-chemical properties (dopant concentration, crystal phase and particle size) of Cu-doped TiO(2) nanoparticles on inactivation of Mycobacterium smegmatis (a model pathogenic bacterium) was investigated under three light conditions (complete dark, fluorescent light and UV light). The survival rate of M. smegmatis (in a minimal salt medium for 2 h) exposed to the NPs varied depending on the light irradiation conditions as well as the dopant concentrations. In dark conditions, pristine TiO(2) showed insignificant microbial inactivation, but inactivation increased with increasing dopant concentration. Under fluorescent light illumination, no significant effect was observed for TiO(2). However, when TiO(2) was doped with copper, inactivation increased with dopant concentration, reaching more than 90% (>3 wt% dopant). Enhanced microbial inactivation by TiO(2) NPs was observed only under UV light. When TiO(2) NPs were doped with copper, their inactivation potential was promoted and the UV-resistant cells were reduced by over 99%. In addition, the microbial inactivation potential of NPs was also crystal-phase-and size-dependent under all three light conditions. A lower ratio of anatase phase and smaller sizes of Cu-doped TiO(2) NPs resulted in decreased bacterial survival. The increased inactivation potential of doped TiO(2) NPs is possibly due to both enhanced photocatalytic reactions and leached copper ions.