Abstract:Further development of capillary electrochromatography (CEC) is to some extent restricted by column technology. Packed capillary columns are most commonly used in CEC because of higher sample capacity and higher sensitivity than open tubular columns, and better reproducibility and uniformity than monolithic columns. Fritting is the core component for the fabrication of packed capillary columns. Therefore various fritting technologies attract continuous attention from analytical community. A convenient fritting method was developed in this study. In contrast to the reported single-particle fritting, this method applies a multi-particle fritting technology to hold stationary phase in capillary columns. Several large porous particles smaller than the column internal diameter were tapped in and immobilized in inlet and outlet of the packing material bed due to direct and indirect keystone effect. Except the smallest permeability by the sintered frit and the lowest breaking pressure by the single-particle frit, EOF mobility and peak dispersion of the multi-particle frit were at the same levels with the formers. In addition, all the three frits avoided bubble formation. It demonstrated that the multi-particle frits met the general requirements of permeability, mechanical resistance and efficiency for packing capillary microcolumns as well as the sintered frits and the single-particle frits. Thus, peak efficiency around 4.3 μm plate height (approximately 232,560 plates per meter) was obtained by multi-particle fritted capillary columns with electrokinetic packing, compared to 6.5 μm plate height by single-particle fritted columns with slurry pressure packing. In particular, the multi-particle fritting was simpler, faster, and more reproducible than the sintered fritting, and the multi-particle fritting was suitable to pack capillary columns of various capillary bore sizes owing to rich commercial resources of fritting particles of various diameters. Multi-particle fritted columns offered satisfactory run-to-run and column-to-column reproducibilities for retention factor, plate height and peak area (precisions of 4.1-9.3% for 10 replicated columns, and precisions of 0.9-3.1% for 30 replicated trials). They also had consistent CEC performance (differences of 1.1-3.9% between the first and 31 st day) during a lifetime more than one month. Application examples in packing capillary columns of 75 and 100 μm i.d. and CEC analysis of sixteen polycyclic aromatic hydrocarbons prove the diversity and reliability of the multi-particle fritting in column technology.

Fingerprint Development for Ginkgo Biloba Extracts by Pressurized Capillary Electrochromatography: Comparison of Column Types.

Study on fingerprint of Ginkgo Leaves by pressurized capillary electrochromatography

Study and Application of Fingerprints of Ginkgo Biloba Leaves Preparations

[HPLC Fingerprint of the Tablets of Ginkgo Biloba L].

Multi-particle Frits for Packed Capillary Columns in Electrochromatographic Use

Study on Pressurized Capillary Electrochromatography As an Fingerprint Analytical Method for Cortex Phellodendri

Electrochromatographic Performance of Graphene and Graphene Oxide Modified Silica Particles Packed Capillary Columns

In-line Vis-NIR Spectral Analysis for the Column Chromatographic Processes of Ginkgo Biloba Part I: End-point Determination of the Elution Process

Separation and Determination of Coumarins in Fructus Cnidii Extracts by Pressurized Capillary Electrochromatography Using a Packed Column with a Monolithic Outlet Frit

In-Line Vis-NIR Spectral Analysis for the Column Chromatographic Processes of the Ginkgo Biloba L. Leaves. Part II: Batch-to-Batch Consistency Evaluation of the Elution Process

Development of a quality evaluation method for Fructus schisandrae by pressurized capillary electrochromatography.

Electrochromatographic Characterization of Methacrylate Ester-Based Monolith and Capillary Electrochromatography Separation of Flavonoids

Simple Method for Simultaneous Quantitation and Fingerprint Analysis of Ginkgo Biloba Tablets by High Performance Liquid Chromatography-Uv-Evaporative Light Scattering Detector

Separation and quantitative analysis of coumarin compounds from Angelica dahurica (Fisch. ex Hoffm) Benth. et Hook. f by pressurized capillary electrochromatography.

Fingerprint analysis of Rhizoma chuanxiong by pressurized capillary electrochromatography and high-performance liquid chromatography.

Preparation and characterization of monolithic columns for capillary electrochromatography with weak electroosmotic flow

Separation of Pyridazinone Derivatives Using Pressurized Gradient Capillary Electrochromatography

Simultaneous Identification of Characteristic Components in HPLC-PDA-ELSD Fingerprint Profile of Ginkgo biloba Leaves Extract

Construction Of Microflow Evaporative Light Scattering Detector Coupled With Pressurized Capillary Electrochromatography And Its Application

Epinephrine‐modified Methacrylate Monolithic Column with Fumed Silica Nanoparticle for Pressurized Capillary Electrochromatography

Pressurized capillary electrochromatography: Instrumentation, columns, and applications