Abstract:Cellulose acetate (CA) mixed-matrix membranes incorporating polyvinylpyrrolidone (PVP), bentonite (B or Ben), graphene oxide (GO), and titanium dioxide (TiO2) were prepared by the phase inversion separation technique for oil/water separation. An investigation was performed where the mixed-matrix membrane was tested for the separation performance of hydrophilic and hydrophobic surface properties. An ultrafiltration experiment at the laboratory scale was used to test dead-end ultrafiltration models developed for the treatment performances of oily wastewater under dynamic full-scale operating conditions. Artificial oily wastewater solutions were prepared from hexane, toluene, and engine oil with Tween80 emulsions for oil removal treatment using composite membranes. The impacts of material hydrophilicity, weight loss, permeability, and pore size were investigated, and it was found that the oil retention of membranes with larger pore sizes enabled much more sophisticated water flux. The CA-GO-, CA-B-, and CA-TiO2-incorporated membranes achieved pure water flux (PWF) values of 45.19, 53.41, and 100.25 L/m2h, respectively. The performance of CA-TiO2 in oil/water emulsion rejection was assessed, and the rejection of engine oil/water, toluene/water, and hexane/water mixtures was determined to be 95.21%, 90.33%, and 92.4%, respectively. The CA-based mixed-matrix membrane portrayed better antifouling properties due to enhanced hydrophilicity and water molecules. The CA-TiO2-incorporated membrane possessed the potential to provide high separation efficiency for oily wastewater treatment. This study demonstrates the potential of fine-tuning membrane performances through material hybridization to achieve efficient wastewater treatment.

[Preparation of Triolein-Embedded CA Membrane and Its Characteristics].

Cellulose nitrate membrane formation via phase separation induced by penetration of nonsolvent from vapor phase

Preparation and Properties of Cellulose Triacetate (CTA)-PVDF Composite Membrane with Hydrophobic/hydrophilic Properties for Membrane Distillation

Preparation and characteristic of triolein-embedded composite sorbents for water purification

Preparation and Characterization of Cellulose Triacetate Membranes Via Thermally Induced Phase Separation

Selective Removal Of Organochlorine Pesticides (Ocps) From Aqueous Solution By Triolein-Embedded Composite Adsorbent

A Biomimetic Absorbent For Removal Of Trace Level Persistent Organic Pollutants From Water

Preparation and Characterization of a Novel Adsorbent for Removing Lipophilic Organic from Water

Fabrication of cellulose acetate ultrafiltration membrane with diphenyl ketone via thermally induced phase separation

Ionic Liquid Assisted Electrospun Cellulose Acetate Fibers for Aqueous Removal of Triclosan

Preparation and Adsorption Performance of Cellulose Acetate Fiber-Chitosan/Titanium Dioxide Surface Layers Composite Membranes Prepared Based on a Sol-Gel Method

Removal of persistent organic pollutants from micro-polluted drinking water by triolein embedded absorbent.

Effect of Solvent and Coagulation on Morphologies of Membrane

Study on the Preparation of Cellulose Acetate Separation Membrane and New Adjusting Method of Pore Size

Investigation of unique interactions between cellulose acetate and ionic liquid [EMIM]SCN, and their influences on hollow fiber ultrafiltration membranes

Modifying Cellulose Acetate Mixed-Matrix Membranes for Improved Oil-Water Separation: Comparison between Sodium and Organo-Montmorillonite as Particle Additives

Study on the Preparation of Dibenzoyl-L-tartaric Acid(L-DBTA) Imprinted Composite Membranes and Its Properties

An Assessment of the Catalytic and Adsorptive Performances of Cellulose Acetate-Based Composite Membranes for Oil/Water Emulsion Separation

Preparation of a highly permeable alumina membrane via wet film phase inversion

Influence of the Dilute‐solution Properties of Cellulose Acetate in Solvent Mixtures on the Morphology and Pervaporation Performance of Their Membranes

Characterization and Adsorption Behavior of a Novel Triolein-Embedded Activated Carbon Composite Adsorbent