Abstract:One of the key challenges to realize a fully integrated transceiver using silicon based processes is the limited output power achievable, especially at millimeter-wave frequencies. Higher output power can be obtained by using various power combining schemes, which typically sum the output power of N identical amplifying stages coherently. Thus to ensure efficient power combining, the input signal must be distributed to all the amplifying stages on the chip with equi-phase and equi-magnitude. While Wilkinson power splitter has been employed for this purpose in the literatures, it becomes bulky and inefficient when N is large, which severely limits the number of outputs that can be combined.In this paper, a network of coupled lambda/2 standing-wave oscillators is employed to distribute the input signal. Proposed formerly for global clock distribution, theoretically, differential signals of equi-frequency, equi-phase, and equi-magnitude can be obtained by taping onto specific points in the network. It should be noted, however, that the network is especially suited for input signal distribution purpose here, since the specific power combining scheme assumes that a grid of N amplifying stages resides on the chip, which matches to the tap points in a perfect way.A 30 GHz prototype network comprised of four coupled lambda/2 standing-wave oscillators using TSMC 0.18 mu m CMOS process has been design. Post-layout simulation results are presented showing that no distinguishable difference in frequency, phase, and amplitude is observed for the multiple output differential signals. The chip has a total area (including pads) of 800 x 990 mu m(2) and has been submitted for fabrication.

Fundamental Wave Phase-Locked Dual-Band Push-Push DRO Using Out-of-phase Wilkinson Power Combiner

Input Signal Distribution Using Coupled Lambda/2 Standing-Wave Oscillators For Coherent Power Combining

Substrate Integrated High-Q Dielectric Resonators for Low Phase Noise Oscillator

A Low Phase Noise, Wideband and Compact CMOS PLL for Use in a Heterodyne 802.15.3c Transceiver

Frequency Stability Optimization of an OEO Using Phase-Locked-loop and Self-Injection-locking

A K-Band CMOS Standing Wave Oscillator Using Digital-Controlled Artificial Dielectric Differential Transmission Lines

A 37.2-Fs, -254.6-db FoM, 47.9-to-56.4 GHz PLL Using Tightly Coupled Dual-core VCO with Implicit 4th Harmonic Extraction Technique

A 68.1-to-73.8ghz E-band Low Phase Noise QPLL with Amplifier Feedback QVCO in 65-Nm CMOS

Low-Phase-Noise Ultra-Flat Optical Frequency Comb Generation Using A Novel Optoelectronic Oscillator

A 140ghz Phase-Locked Loop with 14.3% Locking Range in 65-Nm CMOS

A 56-To-66 Ghz Quadrature Phase-Locked Loop With A Wide Locking Range Divider Chain In 65nm Cmos

Simultaneous dual-band frequency-agile microwave signal generation with a dual loop Fourier domain mode locked optoelectronic oscillator

A W-band Phase-Locked Loop with a Robust Injection-Locked Frequency Divider

A 1.5–2.56-Ghz TDC-Assisted Fast-Locking Wideband Fractional-N CPPLL with Phase Noise of $-$ 138 Dbc/hz at 1-Mhz Offset Frequency

Stable Coherent Dual Comb Generator with Dual-Heterodyne Phase Error Transfer and Heterodyne Optical Phase-Locked Loop

A low-noise, 0.05–17.8-GHz fractional-N phase-locked loop with two parallel synchronized dual-core voltage-controlled oscillators

A 8.5 GHz phase locked loop with split-load divider

Broadband Optical Frequency Comb Generation Utilizing a Gain-Switched Weak-Resonant-Cavity Fabry–Perot Laser Diode under Multi-Wavelength Optical Injection

A Digital Phase Lock Loop for an External Cavity Diode Laser

Integrated Semiconductor Laser Optical Phase Lock Loops

Waveband-shift-free optical phase conjugator based on difference-frequency generation