Abstract:Fault diagnosis of induction motors (IMs) through stator stream analysis is a key area in maintenance systems due to its non-invasive nature and low hardware and software requirements. However, the industrial application of this method faces challenges, particularly in estimating stator winding resistance accurately, especially in large IMs operating at shallow slips. The fundamental leakage can mask fault components until the damage is severe, often leading to short circuits. This article suggests a new approach for fault diagnosis based on analyzing the difference in errors between actual stator streams and estimated currents obtained from a virtual model of the IM. These differences are indicators of estimation errors. To enhance fault detection, these error values are multiplied by the estimated stator currents, forming the basis of an adaptive mechanism. This mechanism utilizes proportional–integral regulators to adjust the estimation process, improving the accuracy of detecting asymmetric faults across all stator phases. The estimation of stator winding resistance, which changes due to intern–turn short circuits, is achieved online using a classical model reference adaptive system. However, estimating stator resistance in a reference frame is challenging, particularly when an incipient short circuit fault is present. The stability of the designed method is ensured through the application of Popov's criterion of inequality in its design. Popov's criterion guarantees system stability under various operating conditions. By incorporating Popov's criterion into the design, the designed technique can maintain stability while accurately detecting and estimating different levels of short-circuit faults in various IM operating modes. Empirical results demonstrate the effectiveness and significance of the designed strategy in fault diagnosis of IMs, highlighting its potential for practical industrial application.

Online detection of endwinding contamination in industrial motors

A Novel Online Stator Ground-Wall Insulation Monitoring Scheme for Inverter-Fed AC Motors

Online Monitoring of Capacitance and Dissipation Factor of Motor Stator Winding Insulation During Accelerated Life Testing

Detection of Stator Winding Faults in PMSMs Based on Second Harmonics of Phase Instantaneous Reactive Powers

Non-Invasive Fault Detection of Stator Windings of Induction Motors

Quasi-Online Technique for Health Monitoring of Stator Winding Insulation in Inverter-Fed Motor Using Switching Transient Voltage Response

An innovative MRAS-based technique for online detection of short-circuit faults in three-phase induction motor windings

Handling Stray Flux Signals for Stator Turn Insulation Degradation Monitoring

Stator inter-turn fault detection for the converter-fed induction motor based on the adjacent-current phase-shift

An Online Groundwall and Phase-to-Phase Stator Insulation Monitoring Method for Inverter-Fed Machine.

Diversified Assessment of Ground-Wall Insulation in Inverter-Fed Motors by Using Transient Characteristics of Leakage Current

Comparative Study of Neutral-Voltage-Based and Leakage-Current-Based Online Condition Monitoring Methods for Stator Insulation of Inverter-Fed Machines

Stator Inter-Turn Fault Diagnosis by Motor Current Signature Approach

Online Condition Monitoring of Line-End Coil Insulation for Inverter-Fed Machine by Switching Oscillation Mode Decomposition

Online Condition Monitoring of Line-end Coils Insulation for Inverter-fed Machine by Switching Oscillation Mode Decomposition

Online Estimation of Per-Phase Stator Resistance Based on DC-Signal Injection for Condition Monitoring in Multiphase Drives

Characteristic Research on the Sensor for Inter-turn Partial Discharge Measurement of Inverter-fed Motor Winding

Induction Motor Stator Winding Inter-Tern Short Circuit Fault Detection Based on Start-Up Current Envelope Energy

The Effect of Bearing Impedance on Online Condition Monitoring for Rotor Winding Insulation of Doubly-Fed Induction Generator

Impaired-Cooling-Condition Detection Using DC-Signal Injection for Soft-Starter-Connected Induction Motors

Identification System for Short-Circuit Fault Points in Concentrated Stator Windings of Motors