Abstract:Analytical expressions describing the variability of effective constitutive parameters of nonmetallic metamaterials, as a function of the constituent geometric and material parameters and their variations, have been developed from the total differential of Clausius-Mossotti expressions (using Mie dipole polarizabilities) for the effective (bulk) constitutive parameters of the metamaterial. In practice, these expressions are important for estimating the performance of a metamaterial with particular variations in the parameters of its constituents that arise during the fabrication process, and can be used to guard against extinction of desired double negative (DNG) behavior. With the derived expressions, the effects of parameter variations on effective constitutive parameters of nonmetallic metamaterials have been analyzed for three types of metamaterials: (i) cubic arrays of identical magnetodielectric spheres; (ii) cubic arrays of dielectric spheres with equal radius but two different permittivities; and (iii) cubic arrays of dielectric spheres with equal permittivity but two different radii. These effects are evaluated in terms of the calculated variations in values of the effective constitutive parameters of the metamaterial in the vicinity of the DNG or single negative (SNG) band for particular geometric and material parameters and their variations. Results show that variation in the following parameters impacts DNG bandwidth. Listed in order from greatest to least influence: (i) sphere radius; (ii) sphere permittivity and permeability; (iii) lattice constant of the array; and (iv) the constitutive parameters of the array medium, all impact the width of the achievable DNG band. For particular cases studied here, results also show that the DNG behavior may be extinguished if there are 0.78%, 0.016%, and 0.016% variations in all parameters of metamaterial types (i), (ii), and (iii), respectively, as defined above. For the design of non-metallic metamaterials with inclusions, having arbitrary material parameters, in either periodic or random arrangement, the presented results can give a qualitative guide on the level of fabrication tolerances that should be achieved in order to observe the predicted SNG or DNG behavior experimentally. (C) 2013 American Institute of Physics. [http://dx.doi.org/10.1063/1.4790714]

Rational design of double-negative metamaterials consisting of 3D arrays of two different non-metallic spheres arranged on a simple tetragonal lattice

Traveling Waves on Three-Dimensional Periodic Arrays of Two Different Magnetodielectric Spheres Arbitrarily Arranged on a Simple Tetragonal Lattice

Analysis of Double-Negative (DNG) Bandwidth for a Metamaterial Composed of Magnetodielectric Spheres Embedded in a Matrix

Design and mathematical modeling of DNG metamaterial having six-band capabilities with high effective medium ratio

Analysis and design of double negative metamaterial offering seven operating bands with minimum frequency ratio

Double Negative Metamaterial Based on Moebius Strip

Statistical analysis of affect of parameter variations on double-negative behavior of metamaterials

A Double-Negative Waveguide Metacomposite Enabled by Ferromagnetic Microwires

Development and evaluation of wideband negative response in ultra-thin polygon metamaterial

Effects Of Parameter Variations On Negative Effective Constitutive Parameters Of Non-Metallic Metamaterials

A novel 3D polygonal double-negative mechanical metamaterial with negative stiffness and negative Poisson's ratio

Dual-polarized Bidirectional Three-Dimensional Metamaterial Absorber with Transmission Windows

Achieving Anisotropy in Metamaterials Made of Dielectric Cylindrical Rods

Numerical demonstration of a three-dimensional negative-index metamaterial at optical frequencies

Low Loss Negative Refraction Metamaterial Using a Close Arrangement of Split-Ring Resonator Arrays

Development of double-layer metamaterial with high effective medium ratio values for S- and C-band applications

Systematic design and realization of double-negative acoustic metamaterials by topology optimization

FDTD Analysis on the Interaction between Electromagnetic Wave and Double-Negative Metamaterials

FDTD Study on Back Scattering of Conducting Sphere Coated with Double-Negatibe Metamaterials

Three-dimensional Negative-Refractive-Index Metamaterials Based on All-Dielectric Coated Spheres

Metacomposites Containing Ferromagnetic Microwires